-
Anonymous users2024-01-24Bathroom heaters and ventilation are not working, it is due to your wiring to see if there is a problem, and also to see if it works. Is he working properly? If it doesn't work properly, it may be that there is no power connection, or it may be a mechanical failure, which needs to be repaired to know.
-
Anonymous users2024-01-23Neither the heater nor the ventilation in the bathroom worked.
It's all due to line faults and short circuits, so check the lines first.
It's unlikely that it's a problem with the device, and it can't be that it doesn't work all at once.
-
Anonymous users2024-01-22If it is working with electricity.
It could be out of power.
Check the toilet opening under the main switch.
Push it up and you're good to go.
-
Anonymous users2024-01-21If the heating and ventilation of 3000 are not working, you may have a problem with this bath bomb and need to change it.
-
Anonymous users2024-01-20If the heater and ventilation fan in the bathroom are not working at the same time, it is likely that the electrical circuit is faulty, and the electrical system should be checked first.
-
Anonymous users2024-01-19The bathroom heater and ventilation are not working properly, which may be caused by a wiring problem.
-
Anonymous users2024-01-18Bathroom heaters and ventilation do not work in general. The power went out, right? Find out.
Looking at the problem description, first of all, the ventilation switch, heating lamp and lighting can be turned on and used. Then the problem is on the way. It should be that the power supply line of the heating lamp and the lighting lamp is diverged when wiring, and the line of the ventilation switch is connected to the power supply line of the lighting line. >>>More
Only warm air can be blown, or bath bombs can be installed. There are also some simple facilities for keeping warm, adding shower curtains, shower covers and other auxiliary methods to reduce heat loss.
The heating in the bathroom and kitchen is turned off, which increases the pressure on the living room heating.
Consider checking the wiring first, and then replace the bulb, if there is a problem with the wiring, replace it or burn. >>>More
You find a place with a pressure gauge on the way, look at the pressure difference between the supply and return water, and compare it with the adjacent loop, if the pressure difference is too large, it is blocked. You can check it like this, close the inlet and return valves at the same time, wait until the pipeline is completely cooled, then you open the valve, release water from an intermediate point, please leave one person at the inlet and one person at the return port, see which side is hot first, you can find the blockage.