Bathroom leakage, what material can be made directly waterproof without knocking on the tile, please

Updated on Bathroom 2024-07-03
4 answers
  1. Anonymous users2024-01-24

    In this case, it is best to use the upgraded version of Qinglong transparent glue, that is, Qinglong No. 3, no need to knock off the tile again to do waterproofing, it can be directly painted on the tile, it is transparent, and the completion will not affect the original decorative effect of the tile, and waterproof, wear-resistant and foam-resistant, and 1 kg can brush 4 square meters, relatively cost-effective, recommended use.

  2. Anonymous users2024-01-23

    Waterproof glue and white cement stirring caulking! After filling the bathroom, keep it dry for two days, and then use a shovel to remove the excess white cement from the edge of the gap.

  3. Anonymous users2024-01-22

    First of all, the bathroom is waterproof, it needs to be done on the cement base, not on the tile, it needs to be waterproof before it can be tiled, so as to ensure a good effect. And now some businesses on the market are advertised that they can directly spray on the tile to produce a good waterproof effect, which is unrealistic and unscientific.

    Secondly, there is a water leak in the bathroom, and the most important thing now is to find the cause of the leak:

    1. Find a professional hydropower worker to check whether the pipeline is ruptured and causes water leakage, etc., if it is a pipeline problem, it is necessary to repair the pipeline in time to solve the water leakage problem;

    2. If there is no problem with the pipeline, then consider that the waterproof layer is not done well and cause water leakage, if the local water leakage is serious, it is recommended to use the kitchen and bathroom waterproof slurry to do the waterproofing again, so as to fundamentally solve the problem.

  4. Anonymous users2024-01-21

    Qinglong has a waterproof glue called Qinglong No. 3, which seems to be waterproof without knocking on the tiles.

Related questions
1 answers2024-07-03

There are many reasons for water seepage in the bathroom, and it is necessary to find a professional and experienced person to confirm before you can decide whether you need to knock on the tile for repair.

7 answers2024-07-03

The floor heating water pipe is under pressure, and the pressure water pipe is impossible to repair from the inside, the reason is that the amount of glue is too large, and the water in the pipe needs to be drained clean, which is almost impossible to complete, so in this case, the most reliable way is to disassemble the ground, and then replace the damaged water pipe, otherwise it is difficult to achieve the purpose of maintenance.

16 answers2024-07-03

Do not smash the floor tiles to judge the severity of the bathroom leakage, is a slight water leakage, the bathroom does not smash the tile with waterproof paint is reliable, after all, the waterproof material without smashing the brick can prevent the bathroom slight leakage, can also play a certain waterproof protection effect. It will not destroy the original decoration either. It is enough to use waterproof leak repair paint. >>>More

4 answers2024-07-03

OK. The year before last, the water leakage in the house was more serious, and my house had just been installed for a few years, and I didn't want to remove the bricks. I found a professional master on the circle of friends to do a water quality guarantee without knocking tiles for 2 years, and I haven't seen any problems until now.

6 answers2024-07-03

If the waterproofing cannot be done on the surface, it must be knocked out and redone, and it should be done once under the caisson, and then done again after filling it in just in case.