How to solve the problem that the toilet still keeps flowing after flushing?

The toilet bowl will remain after flushing because the toilet flush valve is not closed tightly, and it can be repaired by the following methods.

Materials required: slotted taper, rubber sheet, double-sided tape.

1. Remove the drainage components first, and then you can remove them by turning them.

2. Pull up the top part of the water inlet assembly, there is a red clip on the pole, reach in and touch it up and down, and the blue part at the top can be rotated and dialed up.

3. The buckle on the blue lid should be pried open first, and the upper one can be pulled out.

4. There is a special sealing ring in the middle of the bottom of the float, which can inject water inside and bulge up, and finally close the water inlet valve.

5. Remove the rubber gasket at the bottom of the float, paste the rubber sheet to the bottom of the gasket with double-sided tape, trim it and then install it back, so that there will be no water leakage.

The reason why the toilet does not stop flowing after use is that the plastic gasket on the outlet hole of the pumping system is aging and elastic enough to be sealed.

Solution: 1. Whether the black semi-circular float on the overboard assembly is properly covered, or the black semi-circular float falls off, or the rope is stuck or the black semi-circular float is deformed;

2. The single toilet downspout component is shaken by hand, if it shakes, it means that the semicircular fixing piece at the bottom of the downspout component is broken or loose.

The water in the water tank, if the pipe full of the downwater assembly flows out, it is necessary to check the water inlet assembly: there is an adjusting screw on the water inlet assembly, which is used to adjust the water level. Try to tighten it first, if not, it may be that the water-stopping core (or water-stop film) in the water inlet assembly needs to be replaced.

3. The water stop is generally sold in the wholesale market of household appliances in the city, and the whole set of flushing equipment is generally sold in the plumbing equipment store of the hardware store, which is simple to replace, and can generally be replaced by itself or the merchant can replace it on behalf of the merchant.