What is the problem of cast in place concrete cracking in the living room

Updated on Living room 2024-06-11
2 answers
  1. Anonymous users2024-01-24

    Cracks can be divided into stressed cracks and non-stressed cracks.

    1. The stress crack is caused by factors such as uneven settlement of the foundation, concrete strength, and plate thickness;

    2. Non-stressed cracks are caused by factors such as temperature, concrete shrinkage, construction, etc., and the time of its appearance is early and late, and the early dry shrinkage cracks will appear in about 2 or 4 hours after the completion of pouring, and some temperature cracks will appear within three months to half a year after the completion and acceptance. Among them, the main construction factors are the large protective layer of the negative reinforcement of the slab (serious collapse of the steel bar), the insufficient protective layer of the concrete at the bottom of the slab or the excessive chloride salt content of the sand.

    If it is a stress crack, there should be more than this, you can follow this direction and then look at whether there are cracks in the same or similar position on your upper and lower floors, if not, you can basically judge that the non-stress cracks caused by the construction quality.

  2. Anonymous users2024-01-23

    I don't know if the location you are referring to is the wall or the top, whether the house is a new house or a second-hand house, I hope to describe it specifically, there are many kinds of concrete cracks, I hope it can help you.

Related questions
2 answers2024-06-11

The thickness of the tiles is within the range of design and consideration, but the thickness of the floor of the shower room is 29cm.

1 answers2024-06-11

Although I am not engaged in civil construction, it is definitely not possible to use such small tendons for such a large span.

1 answers2024-06-11

The following is an introduction to the method of decorating Chinese living room curtains: 1In Chinese home decoration design, different indoor areas have different standards for the degree of privacy concern. >>>More

1 answers2024-06-11

The first is that there is a problem with the graphics card,The video memory of the general graphics card appears virtual welding,There will be a flower screen and strips and the like,And some can't be displayed,The solution is to repair or replace a graphics card,The second way,There is a problem with the display itself,There will also be problems like you said,You can restore the graphics device to its factory value first,It's also the default value, You can adjust it in the lower right corner of the display,Or there are a few buttons below,One of them is a setting button,You restore it to factory value,Maybe it's good, If this can't be restored, it means that there is a problem with the display itself, and it will be repaired by the repair department. >>>More

24 answers2024-06-11

How to decorate the living room? What should I pay attention to in the decoration design of the living room?