How to solve the leakage under the glass bathroom door in the bathroom?

The specific operation steps are as follows: 1. Gong Zhaobi has raw materials for leak filler, interdental ball, and masking paper; 2. First, paste the masking paper firmly along the edge of the leakage part that needs to be treated; 3. After shaking the leak filler, then glue evenly along the edge of the masking paper; 4. After the leak filler is played, use the seam pressure ball to press the leak filler and trim the gap; 5. After trimming the gap, tear off the masking paper, complete the construction, and wait for the leak filler to dry out.

You can use the leak filler to treat the waterproof leak plugging in the bathroom, and the specific operation steps are as follows:

1. Tools and raw materials.

leak filler, interdental ball, masking paper;

2. First, paste the masking paper firmly along the edge of the leakage part that needs to be treated;

3. After shaking the leak filler, then glue evenly along the edge of the masking paper;

>4. After the leak filler is played, use the seam ball to press the leak filler and trim the gap;

5. After trimming the gap, tear off the masking paper, complete the construction, and wait for the leak filler to dry out.

Check the location of the leakage The first thing to do is to go downstairs to check the specific location of the leakage, whether it is near the pipe mouth or a large area of water leakage ,..

Knock out the floor drain If you check that it is only a leak near the pipe, it is basically determined that it is only the waterproof near the floor drain that has not done a good ,..

The floor drain is re-drained The cleaned floor drain is evenly brushed with waterproof paint, and after drying for 24 hours, the waterproof paint is applied for the second time,..

Knock off the bathroom floor tiles If it's not just the waterproofing near the floor drain that isn't done, it's that the entire bathroom isn't waterproofed.

You can search on the Internet to purchase 8 mm or 10 mm, (the general glass door is 8 mm) glass concave inlay, use glass glue at the lower mouth of the glass door, and glue the glass concave inlay to the glass door. If it is too high or too low, the glass door can be adjusted.

At the closing of the bathroom glass door, near the outside of the glass door, the purchased concave inlay can be glued with glass glue, so that the water can only go down from the bathroom glass door and will not leak out of the glass door.

This is a problem in the design of the shower room, and it is impossible to change it now, and the solution is to plug the crack of this glass door with towels and other things every time you take a shower.

Rubber plate on the bottom of the glass turn.

Put a circle of waterproof glass glue.

Just go to the place where the door is sold and buy a strip of glue.

Find a master who repairs the pipes, they have a glue that can fill the holes.

There should be the kind of adhesive strip sold on the market, but I don't know if it's good or not, you can buy a piece and install it yourself.