-
Anonymous users2024-01-24Go out to buy a flange (rubber pad) for the toilet, the flange is set at the outlet of the toilet, and then align with the outlet of the sewer pipe on the ground, after the seat is good, do not rush to play the glue, to test the water, if the edge of the water leaks, sit several times, move left and right, after not leaking, use the gasket to flatten the toilet, and then, hit the glass glue, 24 hours later and then use the toilet.
In this case, the interface is generally not connected properly and causes water leakage, but it can only be removed to check the cause of water leakage, and then repaired!
Find a master to install it.
It should be that the installation was not in the right position, and it is better to re-place it.
It should be open glue, the toilet is unloaded, the glue below is cleaned, and then buy a new glue to glue it, wait for the glue to dry, and buy the special glue for the toilet bowl on the hardware.
The part of your toilet that automatically feeds is broken and can't be automatically stopped. >>>More