-
Anonymous users2024-01-241 All 1Pressure the water pipe first, and then the hot water pipe should also be used to prove that the water pipe is fine.
2.It is best to have a partition between the shower and the toilet, and the water vapor acts directly on the door and wall when taking a bath, so it is best to make a partition, and at worst to make a shower curtain;
3.Then check whether the floor tiles have backflow water, if there is backflow, then the water has accumulated in the door for a long time, and seeps into the wall and the floor outside the bathroom along the marble gap;
3.If there is no backflow of water, in order to avoid a big fight, first try to scratch off the original hook on the bathroom floor wall, and use a good waterproof grout to scratch it again.
Be sure to tick carefully to plug the loopholes that may return to the bottom and walls of the dwelling, and if it doesn't work, then knock on the wall.
-
Anonymous users2024-01-23Make a waterproof interface agent or scrape a layer of polyurethane.
Cause of water leakage:
The waterproof layer is divided into a horizontal waterproof layer and a vertical waterproof layer on the side, the horizontal waterproof layer leaks to the downstairs if there is a problem, and the vertical waterproof layer on the side leaks to your own home if there is a problem. Water leaking into the corner of the outside of your bathroom or the door of the bathroom is first sure that the vertical waterproof layer on the side is broken somewhere, otherwise no matter how much water can only come up from the tile surface. In fact, the damp marks we see in the corner of the bathroom or the door of the bathroom are not vertically leaked in the past, theoretically speaking, as long as the waterproof layer is damaged somewhere, the open water in the bathroom penetrates below the tile surface from the corner, tile surface and joints or any other possible place, and is concentrated in the mortar layer, then the mortar layer is equivalent to becoming a water layer, and then concentrated in the waterproof layer where the damage leaks downstairs. >>>More
This depends on whether it is a problem with the waterproof layer or the water pipe, of course, you can dig the wall to redo the waterproofing, or you can not dig the wall, and directly use CPC leak-proof agent to brush the gap in the tile. This thing can be seen in the nest.
1. Find out the cause of water seepage on the wall, and then take the right measures to deal with it. If the water pipe is leaking, it is necessary to find the leakage point of the water pipe, and if the waterproofing is not done well and causes water seepage, then it is necessary to do a good job of waterproofing the wall. >>>More
There is only one way, and that is to repaint the wall, then tile it, and fill in all the joints. This can only be done, otherwise the wall will be wet, and no matter how you get it, you won't be able to get it.
Bathroom leakage is generally two situations: leaking water pipes or leaking bathroom tile joints. >>>More