-
Anonymous users2024-01-24Gypsum board ceiling want to hide the light strip at least to ensure that there is 8CM, if you do not do the light strip, directly do the gypsum board ceiling to take the lowest beam bottom of the room, gypsum board ceiling inside the wooden keel is generally 2 4 also have 3 6, home decoration and tooling is not the same, tooling also has 6 and 8 centimeter threaded iron rod with aluminum components, the cost is cheaper, gypsum board is generally 3 to 5 mm, gypsum board can also be lined board, lining board is generally 9 centiboard (home decoration) or 5 centiboard (tooling, or simply not lined).
The price of chandeliers varies greatly, from one hundred and eighty yuan to thousands, or even tens of thousands, to tens of thousands.
It is to use a light strip to install light on the edge of the modeling ceiling, and it is usually used as an auxiliary light source to achieve the effect of halo.
The height of the ceiling is related to the size of the room in your home, the room is large, the ceiling should be higher, the room is small, and the ceiling can be relatively low. 30 40 square meters of hall, the ceiling height should not be less than meters; 40 The upper hall should not be lower than 3 meters. Offices below 30 should also be upward.
1. First determine the length of the light strip to be installed, and then cut the appropriate light strip length. Note that integer truncation is required. Because only by cutting it off from the cut will it not affect the circuit. If it is cut at will, it will cause a unit to not light up. >>>More
I don't know what you mean by hiding in glass, but the general chandelier refers to the crystal chandelier, which also has a lampshade to isolate the dust.