About whether the bathroom has a water pipe

Updated on Bathroom 2024-06-24
4 answers
  1. Anonymous users2024-01-24

    You use bricks to wrap the water pipes in bricks, which means that the pipes are not in the middle of the bricks, and in this case, you generally can't touch the water pipes. If you have to make sure that the drain pipe is hit, you only need to stop using the bathroom for two days (that is, there is no water on the ground) to see if there is a watermark on the side.

  2. Anonymous users2024-01-23

    Can't hit, the red bricks and tiles outside the water pipe are 10 cm thick.

  3. Anonymous users2024-01-22

    Drop the towel rod and the screws, and poke the nail with a nail, [don't use force].

  4. Anonymous users2024-01-21

    Absolutely can't hit, the drill bit of the electric drill is generally five centimeters.

Related questions
1 answers2024-06-24

If you don't plan to re-shovel a wall. Enlarge the hole with an electric hammer, then cut the PPR water pipe, connect both ends with an elbow and a water hose, and then connect it again.

1 answers2024-06-24

At least hit the leaky pipes where the tiles were had to be knocked out. Close the sluice gate, on the basis of the original pipe, where there is a joint, the distance is close, and replace a water pipe. You can't fool around, otherwise, if the tiles are repaired, they will leak.

1 answers2024-06-24

How much budget is for renovating the bathroom; Bathroom decoration This also requires a decoration standard (4 square meters). >>>More

2 answers2024-06-24

No, the anti-bend must be installed at the mouth of the toilet, the floor drain, if it is installed in the middle, then the section of the pipeline from the floor drain to the anti-bend will produce dirt and smell after a long time.

5 answers2024-06-24

1. When decorating the bathroom or kitchen, be sure to insulate the pipes to reduce the noise generated by the upstairs and water. During construction, the sewer pipes of the bathroom or kitchen should be closed first, and only local treatment should be done; Secondly, the toilet sewer pipe should be surrounded by soundproof panels or soundproof cotton and other soundproof materials to package the pipes in multiple layers; Finally, the light steel keel or light brick is used to enclose the sewer riser to achieve a good effect of reducing noise and moisture. Note: >>>More