The tailstock sleeve of the lathe slid inside, and the thimble does not turn when the thimble is pus

Updated on Foot of the bed 2024-06-27
2 answers
  1. Anonymous users2024-01-24

    The tailstock sleeve looks like it's screw-driven, so it won't slip, right?

    Is the top not turning another problem? If it does not turn, disassemble and replace the bearing.

  2. Anonymous users2024-01-23

    The thrust bearing inside is broken, and only one radial bearing can be idled, and the torsion force under the load increases. Just replace the bearings.

Related questions
In order for the lathe tailstock sleeve to work properly, what needs to be used for circumferential
1 answers2024-06-27

Barrel hole Morse taper positioning drill bits and all kinds of tools with Morse taper. The cylinder positioning key and the keyway positioning screw rod drive the nut to move in an axial linear line along the keyway, and the nut is fixed with the lathe tailstock sleeve, so the lathe tailstock sleeve can move axially.

How to solve the reaming hole of the tailstock of ordinary lathes and the insufficient length of the
3 answers2024-06-27

Hello! There are sold ones, elongated sockets, and reamers are also long. >>>More

Lathe tailstock plate tooth sleeve processing
1 answers2024-06-27

1. The full taper is determined according to the taper hole of the tailstock sleeve. 6140 is Mohs 5 and 6132 is Mohs 4.

English translation of lathe tailstock how to say lathe tailstock in english
2 answers2024-06-27

Hello! Lathe tailstock.

Lathe tailstock >>>More

The tailstock of the lathe knows the feed
1 answers2024-06-27

The manual feed of the tailstock is changed to a motor plus reducer drive, and the motor drives the reducer to transmit the power to the top feed screw through the clutch to achieve feed. When an automatic feed is not required, the clutch is disconnected and the operator can turn the lead screw by the handwheel to achieve the center feed.