Can 107 dry powder glue be waterproof for the bathroom?

The closed water test is generally done for 48-72 hours, and there is no leakage after the closed water test, which can only show that there is no missing part in the construction of waterproofing, and the current waterproof function is sound, but it is not guaranteed that there will be no water leakage in the future.

Special attention needs to be paid to the vicinity of the sewer pipe, and the yin and yang corners of the pipe and floor drain need to be made into R angles.

The waterproof height of the bathroom, the ground needs to be done, and the wall needs to be at least meters, and it is recommended to do the full height. Your 20 cm is clearly not up to the mark. The workers said yes, but this was just an excuse for them to cut corners.

Judging from the effect of the picture, it is recommended to re-do the waterproofing with mortar waterproofing agent, while it is not very troublesome!

107 is useless to do waterproofing, it doesn't matter if you pour a layer of cement sand paddle surface on top, use PPS to do another layer, and the merchant does it. It is very troublesome after not doing it well, and the maintenance cost is very high.

First of all, I personally don't know much about the material of 107 dry powder glue, so it is difficult to evaluate whether it has a waterproof effect, but I can take a look at the specific construction problems you are puzzled about.

The closed water test is generally done for 48-72 hours, and there is no leakage after the closed water test, which can only show that there is no missing part in the construction of waterproofing, and the current waterproof function is sound, but it is not guaranteed that there will be no water leakage in the future.

Special attention needs to be paid to the vicinity of the sewer pipe, and the yin and yang corners of the pipe and floor drain need to be made into R angles.

The waterproof height of the bathroom, the ground needs to be done, and the wall needs to be at least meters, and it is recommended to do the full height. Your 20 cm is clearly not up to the mark. The workers said yes, but this was just an excuse for them to cut corners.

Judging from the effect of the picture, it is recommended to re-do the waterproofing with mortar waterproofing agent, while it is not very troublesome!

Introduction to Haoyang waterproof products.

Haoyang JS waterproof slurry (acrylic acid copolymer emulsion cement-based waterproof slurry) is a waterproof material with alkali-resistant synthetic modified cement substrate, K-11 waterproof slurry is prepared with imported and domestic raw materials, and a series of products produced by synthesis. The product is easy to construct and operate, and has excellent performance and surpasses similar products.

Second, the main features.

1. It can be constructed on a wet base surface, and the waterproof layer has high mechanical strength and good wear resistance.

2. The coating can prevent moisture and salt pollution and inhibit the growth of mold.

3. The concrete can still be breathable, based on the cement-based nature of this product, the waterproof layer can be directly paved with tiles, mosaics, etc.

4. Resist high hydrostatic pressure and have the waterproof function of negative water surface.

5. This product has two appearances: white and gray.

3. Scope of application:

1. It is used for indoor and outdoor cement concrete building structures, precast concrete structures, cement plastering and brick walls and other bottom base surfaces.

2. Underground parking lanes, underground tunnels, water supply and drainage pipes, floor walls and floors.

3. This product is non-toxic and harmless, and can be directly used in drinking batteries, swimming pools, fish ponds, etc.

4. This product is also suitable for all kinds of waterproof projects on the front or back water surface.