-
Anonymous users2024-01-24I'm a distributor of toilets, and I'll tell you that it has nothing to do with the size of the water flow or the water pressure. (If your home is fully automatic, it's all about water pressure.)
The phenomenon you mentioned is likely to be that the toilet flush pipe in your house is not smooth, and the reason may be 1. The pipe is not glazed. That is, the inside of the pipe is not glossy. Hehe, if you go up and down, the flushing resistance will be great.
2. There are foreign bodies in the pipeline. Generally, the heavy water flow is not enough to wash away, and the foreign body has been blocked at the bend of the pipe. And the foreign body is not large. The shape is irregular. Therefore, the time is blocked.
3. There are foreign objects in the water channel of the water tank. Give it points.
-
Anonymous users2024-01-23The reason is that only half of the fate is wrong.
The sewer pipe has cast iron pipes. PVC pipe.
Comparatively speaking, if the cast iron pipe is installed, the casting sand left by the casting in the pipe is not properly treated. Iron Thorns. As soon as there was a piece of paper, I put it on hold. Half-pass state.
If it is a PVC pipe. There is no such problem.
Here's what I estimated.
You push it all through with a few mop strokes. It won't be blocked sometimes.
It is not excluded that the water level of the tank is low.
-
Anonymous users2024-01-22The size of the water flow and the water pressure are all related.
In the case that it is determined that the nut that is not in contact with the water supply pipe and the toilet bowl is not loose, it may be that the sealing gasket was not padded when the toilet was installed, or the sealing gasket is broken, use a blade to separate the glass glue under the toilet bowl, and then check or replace the lower sealing ring.
There are also in-line and S-bend, but the best one is the siphon type, which flushes cleanly.
It could be the reason why the sewer is a little clogged.
How to deal with the broken flush valve of the flush toilet: Grab the total drain and rotate counterclockwise or there are two small plastic cards in the shape of 7 on the left and right of the bottom of the drain, and grab the end of the figure 7 and pull it up with your hand. If you can't repair it yourself, ask a professional master to repair it, ask a professional master to repair it. >>>More
There are two situations of water leakage in the water tank, 1: the outlet valve is leaking, the inspection method is to close the water inlet triangle valve, if it has been leaking, it is the leakage of the water outlet valve, just see whether the seal is deformed, or there are impurities; Another situation is that the button does not pop up, open the water tank lid to make it pop up, generally there is debris stuck, just clean it. 2；The water inlet valve is not closed tightly, the water has been added to the water tank, the water flows out from the overflow port, and the water inlet triangle valve will not flow again after the water inlet valve is closed, but the water in the water tank is still full, you can judge that there is a problem with the water inlet valve, and this situation can clean the valve seal.