-
Anonymous users2024-01-24Take the water pipe first and then do waterproofing to ensure that the water pipe is not well connected and will not leak.
-
Anonymous users2024-01-23Hello, there are regulations on whether the bathroom should be waterproof or water pipes first, and it is the rule to do waterproofing first. 1. The waterway pipeline should be made first; 2. Then do waterproofing; 3. The reason is that the drainage pipe needs to be slotted and drilled, which will damage the waterproofing.
The process of waterproofing the bathroom:
1. Brush the waterproof paint for the first time. Before construction, ensure that the construction site is clean and dry, and the waterproof coating should be coated with no omission, firmly combined with the base layer, no cracks, no bubbles, and no falling off. The coating height is consistent, and the thickness should meet the requirements of the product.
2. Brush the waterproof paint for the second time. Note the first.
First, the second waterproof coating needs to have a certain time interval, and the second time can only be carried out after the first coating is dry, and the specific time depends on the coating. If the interval is too short, the waterproof effect will be greatly reduced.
3. Lay a protective layer. In order to prevent the subsequent construction from damaging the waterproof layer, it is necessary to lay a protective layer on the surface of the waterproof coating. The protective layer should be completely covered with the waterproof layer, no omission, firmly combined with the base layer, no cracks, no bubbles, and no falling off.
4. Closed water test. During the closed water test, the water at the highest point of the ground should not be less than 2 cm, and it should be stored for at least 24 hours, and it will be qualified only after observing that there is no leakage. If there is a leak, it needs to be redone, and it must not be negligent.
5. Grassroots treatment, cleaning, leveling layer, bonding layer, detail additional layer, acrylic waterproof layer, water storage test, protective layer construction, secondary water storage test.
-
Anonymous users2024-01-22Take hydropower first, and then do waterproofing. Closed water test for 48 hours after waterproofing.
First do hydropower, then do waterproofing.
After the water and electricity are done, fill the gap between the floor and the water pipe, and then do the waterproofing. >>>More
It should be waterproof first, and the water and water pipeline laying area in the squatting pit area should be waterproofed first, and then the installation of water supply and water supply and squatting pit should be carried out.
The waterway pipeline should be done first, and then waterproofing, the reason is that the drainage pipe needs to be slotted and drilled, which will destroy the waterproof layer, so the waterway pipeline must be done first, and then waterproofing.
The bathroom decoration should first do the water pipe arrangement, and then make the waterproof layer. According to the rules of the house decoration construction process, the entry of workers into the site is always the first step. If the waterproofing is completed first, then the subsequent construction arrangement of the water pipe, such as slotting and drilling, will inevitably damage the waterproof layer, thus forming a hidden danger of water leakage. >>>More
1.The bathroom should be waterproof first (generally the developer has done waterproofing when handing over the house, in order to prevent building quality problems, it is recommended to do it again to rest assured) and then package the riser! >>>More