-
Anonymous users2024-01-24It is possible to encounter other objects, and this situation will also occur, and there is whether the pull line is short, it is short, change the long line, and it is not in the same line (pull rod line, leather seal).
-
Anonymous users2024-01-23The weight of the rubber raft is not enough, add a little counterweight and it will be done.
-
Anonymous users2024-01-22Close the inlet valve and remove the entire float, connecting rod, bracket and other things in the toilet tank. Take these parts to the plumbing and sanitary ware store and buy a new set of the same parts (you must bring the old ones, you can match them with the same size and shape, otherwise they will not fit). Go back and slowly install the new one and open the inlet valve.
That's it! (Inexpensive), according to my experience, replacing all the new parts is the best solution.
-
Anonymous users2024-01-21Check it out, I hope it helps!
-
Anonymous users2024-01-20It's called a float. The function is to turn off the water switch after the water tank is fullIn other words, if you buy it in reality, it is estimated that it will be dozens of fast, if you want it, if you have online banking, you can rice me, I will sell you, more than a dozen fast.
-
Anonymous users2024-01-19I'm sorry I don't understand this, so don't be surprised.
But I know it's in the common sense book, so I suggest you check it out!!
-
Anonymous users2024-01-18Just tie the broken thread back on.
Are you having a problem with the control valve, is it the float device, and if so, adjust the screws at the top of the float linkage. >>>More
Reasons why the toilet won't drain:
1.Nowadays, a filter will be placed in the toilet tank, and after the filter is used for a long time, it will deteriorate and cause more scale to cause the filter to clog, etc., so it will cause the tap water in the tank to not enter smoothly. >>>More
The split toilet is connected by two bolts, the nut is under the water tank, one on the left and one on the right, remove the nut, and at the same time remove the water pipe, the water tank can be taken down. >>>More
Judging from your picture, it should be your man or worker who used excessive force when installing the water tank inlet pipe, the float was put to the side, and it hit the wall of the Shuizhou laughing box, and the float rose with resistance, of course, it was not closed, you said that you pulled the screw rod and did not enter the water, which means that you restored quite well, if the water level has not been adjusted, you use pliers to clamp the position of the water tank inlet pipe joint to tremble a little bit, let the float turn clockwise about 45 degrees, and then readjust. >>>More
I guess because of the water quality problem is a little blocked, there are many people who will use the splayed valve when installing the toilet, and the good splayed valve is filtered, and the splayed valve used for the toilet in the decoration is to remove the filter, and some decoration personnel are not responsible for not dismantling, so there will be such a blockage.