-
If the floor slab is well waterproofed, it is better to lay along the top wall.
If the waterproof treatment of the floor slab is not good, it is better to lay along the corner line of the ground wall; Pay attention to the appropriate safety distance from the ground.
Regardless of the height of the power cord along the wall, waterproof and moisture-proof measures should be considered during construction, and pressure-resistant and aging-resistant wires should be used.
-
Let's put on a hose from the top, it's safe, and the socket is the kind with a protective cover!
-
Suspended ceiling wall combined laying is good.
-
It is generally laid along the ground wall.
Special circumstances, how to facilitate and how to construct.
Socket wire, kitchen socket and bathroom socket wire are used how many square meters of kitchen and bathroom electricity consumption is relatively large, according to 4 kilowatts calculation, the working current is 4 square copper wire through the plastic pipe safety current is 22A, so use 4 square copper wire. >>>More
Lengthen it with standard wiring is fine.
The core of standard wiring technology is tight, firm, and the contact surface is large enough, and there are many specific methods, you can choose one suitable for your own use. >>>More
From what you said, this cable is a lighting tap line, not a power supply. It cannot be used as a power supply. (Socket). >>>More
From what you said, the circuit breaker trips, there are generally these phenomena, 1, the circuit breaker load current is small or damaged, you can do this to rule out the circuit breaker damage, turn off the circuit breaker power supply, the output line of the circuit breaker ---that is, the following line is removed (not the upper incoming line you said), connect to other circuit breakers below to try (preferably greater than the load current of the original circuit breaker, and the circuit breaker with a leakage protector), if not tripped, the original circuit breaker must be replaced. 2. There is a short circuit, leakage or wrong line connection in the output circuit of the circuit breaker (the latter point is less likely to be at home, because it is normal before going out). >>>More
The empty opening has been replaced, and the problem of empty opening can be eliminated. >>>More