What to do if the wall outside the bathroom is peeling

Updated on Bathroom 2024-06-08
10 answers
  1. Anonymous users2024-01-24

    It is necessary to shovel off the original wall of the bathroom, then brush the waterproof paint, and then re-pave the tiles, so as to prevent the wall from peeling again.

    > specific operation steps:

    1. Shovel off the original wall of the bathroom, expose the cement wall, clean the wall, and ensure the dryness of the working surface.

    2. Then brush the waterproof coating, you can choose a better quality waterproof coating, do not brush too thick each time, after brushing, there is a layer of waterproof film formed.

    3. After the coating is completely dry, re-pave the tiles, so that the water on the exterior wall cannot seep into the interior.

    This answer applies to most cases of wall peeling.

  2. Anonymous users2024-01-23

    First of all, if the wall has been waterproofed, it is necessary to consider that the breathability of the wallpaper on the outside of the toilet is too poor, and the moisture is not volatilized, which leads to the production of bacteria, so it will peel. The second is the waterway pressure, which can eliminate the problem of the waterway without continuous pressure loss. It is also possible that the sand layer of the tiles is too thick, the ground is too wet, and the tiles are not dried out, and when the temperature rises, water vapor will come out under the tiles, which will spread along the corners of the wall, causing the wall to peel.

  3. Anonymous users2024-01-22

    The skin of the bathroom is because the waterproofing is not done well, and the bathroom is damp, so tiles should be installed on the wall and do a good job of waterproofing.

  4. Anonymous users2024-01-21

    The skin on the bathroom wall is peeling, which should be waterproof not done well during the previous decoration, and the wall is caused by moisture, so it can only be re-waterproofed.

  5. Anonymous users2024-01-20

    You should not do a good job of waterproofing, so the skin will fall off, and you need to do it again.

  6. Anonymous users2024-01-19

    1. If the base layer is not done well, water-resistant putty should be used;

    2. The waterproofing of the bathroom is not done well, and the waterproofing should be redone.

  7. Anonymous users2024-01-18

    First of all, if the wall has been waterproofed, it is necessary to consider the suspicion that the transdermal permeability of the wallpaper on the outside of the toilet is too poor, and the moisture is not volatilized, which leads to the production of bacteria, so it will peel. The second is the waterway pressure, which can eliminate the problem of the waterway without continuous pressure loss. It is also possible that the sand layer of the tiles is too thick, the ground is too wet, and the tiles are not paved when they are not dry, and when the temperature rises, there will be water vapor under the tiles, which will spread along the corners of the wall, causing the wall to peel.

  8. Anonymous users2024-01-17

    It is necessary to shovel off the original wall of the bathroom, then brush the waterproof paint, and then re-pave the tiles, so that the waterproof prevents the wall from peeling again. Specific operation steps: 1. Shovel off the original wall of the bathroom, expose the cement wall, clean the wall, and ensure the dryness of the construction surface.

    2. Then brush the waterproof coating, you can choose a better quality waterproof coating, do not brush too thick each time, after brushing, there is a layer of waterproof film formed. 3. After the coating is completely dry, re-pave the tiles, so that the water on the exterior wall cannot seep into the interior. This answer applies to most cases of wall peeling.

  9. Anonymous users2024-01-16

    It is because of the dampness so the skin is peeled, and the general treatment method for the dampness of the latex paint wall is:

    1.Remove a slightly larger area of the original wall surface until the plain ash is exposed (that is, remove all the white and latex paint layers);

    2.Wait for the wall to dry and re-scrape the white, apply latex paint (if it is caused by the moisture of the inner wall of the bathroom, it is recommended to do waterproof treatment first);

    3.During the construction process, it is necessary to ensure that each process is thoroughly dried before proceeding to the next construction.

  10. Anonymous users2024-01-15

    The reason for the peeling is the resurgence of the wall, you should check whether the waterproofing of the bathroom is not done well to cause the wall to be damp, the root cause is not leaking, the wall is no longer wet, the skin that has fallen off can be shoveled off, buy wall paste on the Internet, a small area can be repaired by yourself, a large area must ask the master to help, their own workmanship is too rough.

Related questions
10 answers2024-06-08

The possibility of water seepage in the pipeline is greater, otherwise it will not seep downstairs, you can find a building materials supplier to help test the pressure, if the pipe is fine, cut off the corresponding wall tiles in the bathroom, paint the waterproof slurry, and then paste the tiles. The room paint putty is completely removed, the waterproof slurry is applied, and then restored.

8 answers2024-06-08

The methods for water seepage treatment on the bathroom wall include determining the location of the pipe, increasing the height of the waterproof layer, glue plugging and so on. >>>More

5 answers2024-06-08

If it is by the wall of the bathroom moisture, that is, the waterproofing of the bathroom is not done, the solution should be to make the wall of the bathroom meters below the waterproof, shovel the patent leather wall, do not use water inside, wait for the wall to dry thoroughly, scrape the waterproof putty, and then brush the paint.

2 answers2024-06-08

This situation is difficult to cure without re-tiling. You can try to improve the lighting conditions by: >>>More

1 answers2024-06-08

Is the exterior wall wet, look at whether it is the position of the window, it may be the improper use of materials during the construction of the window position, and the operation method of the construction personnel, which is not in place.