-
Anonymous users2024-01-24It is a good thing that the water level in the toilet pool is low, the water does not splash on the buttocks when you defecate, and the water level in the toilet pool cannot be adjusted. However, the water level of the toilet tank can be adjusted, open the lid of the toilet tank, and adjust the length of the float or cable.
Specific steps: 1. Installation and adjustment of the inlet valve.
1. Installation of the inlet valve Take out the parts of the inlet valve. Then install the adjusted water inlet valve on the water inlet hole of the water tank, then cover the gasket, and tighten the nut. (Note: The inlet valve should be installed in such a way that the make-up pipe cannot be discounted or hindered from the work of other parts.) ）
2. Adjust the water volume of the water inlet valve and water tank First of all, turn the card of the inlet valve to the "OPEN" direction. Then pull the inlet valve body to make the inlet valve as a whole raise or lower. The lock and loosening of the card can be found in the logo of the water inlet pipe.
3. Fine-tune the water level of the water inlet valve and water tank.
The adjustment lever can be adjusted to raise or lower the water level of the tank. When the adjustment lever is rotated counterclockwise, the float box descends and the tank water level decreases. On the contrary, by rotating the adjustment lever clockwise, the floating box rises, and the water level of the tank rises.
2. Installation and adjustment of drain valve.
1. Installation and disassembly of the drainage head.
a.Rotate the body counterclockwise, and then take the body upwards.
b.Loosen the fastening nut and remove the spacer. Then install the drain head on the drain hole of the water tank and adjust the appropriate position. Put on the spacer and tighten the nut.
c.According to the diagram, the positioning buckle of the valve body is fastened to the positioning hole of the drain head. Then rotate the body clockwise. After installation, it is OK to hear a "click".
2. Adjustment of the drain valve (small drainage adjustment) The adjustment of the cleaning quilt cup can be adjusted up and down to adjust the amount of water drained by the small gear, the higher the position of the adjustment cup, the higher the water level, the smaller the drainage. On the contrary, the lower the position of the adjustment cup, the greater the drainage.
3. Adjustment of the drain valve (large drain adjustment) The adjustment section switch can make the drain valve drain large. When the regulator switch moves down to seal the hole, the displacement is larger. Conversely, moving upwards opens the hole and distributes less water.
4. Adjustment of the drain valve button Rotary valve body button is simple, which can be rotated 360° to correspond to the direction of the pusher of the button.
This keeps the water level low.
-
Anonymous users2024-01-23Open the lid of the toilet tank by adjusting the length of the float or cable.
The low water level is a float problem, and the water level can be adjusted by adjusting the height of the float. The structure of different water tank accessories is different, and you can explore and adjust the structure of your own water tank accessories or ask a professional master to help.
Plug the drain or it will backflow.
1. First of all, open the lid of the toilet tank, and then observe the position of the float when the tank is full of water. If the water in the tank shows that it is full, and the water inlet of the tank is still flooding, then there must be a leak. >>>More
There are screws in the water tank on the water, and there is an iron that pinched the iron in the middle of the iron and pulled the iron upwards to adjust the low, down is high, open the upper lid of the toilet, you can see the ball linkage mechanism inside. >>>More
Is the toilet tank leaking? If the toilet tank is leaking, reach for the bottom of the water tank, feel the soft rubber plug at the outlet, clean up the surrounding impurities with your hands, and then press it down.