-
Anonymous users2024-01-24Two sewer outlets, because the sewer pipe of the toilet in the house is usually set up in 2 sizes, so the manufacturer often produces a toilet with two sizes of sewers, and later for different sewers, choose to use the appropriate toilet sewer outlet.
-
Anonymous users2024-01-23Some models have only one spout, you can declare it in advance when you buy it, and you can pour a little water to try it after you pick it.
Okay, there is generally a hole underneath this kind of design, so that the design has a large impulse and saves water. It's also not easy to block.
You pull the outlet valve in the middle and rotate it up, so you should be able to get the outlet valve out...
The toilet seal is lower than the spout to prevent aftertaste. The height of the water seal of the toilet bowl is the key to prevent the aftertaste, and the water seal below 50mm is easy to smell bad and should not be used. The height of the toilet seal must meet the standards stipulated by the state, but although the higher the height of the water seal, the better the anti-odor effect, but as the water level rises, the more likely it is to splash water. >>>More
The reason for collecting water is to avoid direct leakage of gas inside.
Reasons for water ingress and troubleshooting:
1.First check the water inlet switch next to the water tank --- turn on the switch. 2. >>>More