-
The reason for collecting water is to avoid direct leakage of gas inside.
-
The closure is to stop things that shouldn't be flowing down the drain.
-
Why should the toilet pipe outlet be closed? It is to prevent the stolen goods from flowing backwards, and it can also prevent odors from appearing.
-
To suffer to prevent the return of water. If the water is gray, it is easy to get into the air and it smells bad.
-
Because it needs to have proper drainage, and then it also needs some closure.
-
If the toilet pipe outlet is closed, it is to prevent odor from returning.
-
The toilet pipe outlet should be grilled because it will have a larger amount of water, and it will be good for flushing to collect some of it.
-
After the toilet pipe outlet is closed, the siphon effect will be more obvious.
-
That's because if you don't close the mouth, the water will not flow everywhere, all over the floor or outside.
-
In the past, it also damaged the flow of water and relieved the pressure and fluctuations at the gate.
-
The sealing of the toilet pipe outlet is mainly for the safety management of the environment.
-
Why is there a charge for toilet pipe outlets? Toilet pipe outlet charges should be charged for environmental pollution.
-
The toilet pipe outlet is closed to prevent backflow.
There are two kinds, the lower row and the lower one, and the back row and then the back...
The toilet seal is lower than the spout to prevent aftertaste. The height of the water seal of the toilet bowl is the key to prevent the aftertaste, and the water seal below 50mm is easy to smell bad and should not be used. The height of the toilet seal must meet the standards stipulated by the state, but although the higher the height of the water seal, the better the anti-odor effect, but as the water level rises, the more likely it is to splash water. >>>More
Draw out a detailed picture to see the layout of your home's interior, etc., including the external surrounding environment, which is a good way to comprehensively analyze how Feng Shui is.
Reasons for water ingress and troubleshooting:
1.First check the water inlet switch next to the water tank --- turn on the switch. 2. >>>More
How much higher ? If the height is not very high, then raise the toilet .