The wall of the bathroom is too thin, and it leaks when you smash it

Summary. Hello, 1.If the steel pipe leaks and cuts the leakage section, re-welds a section of the steel pipe or repairs a steel plate with the same curvature and similar thickness at the crack, and the rust removal treatment should be carried out before welding, and the anti-corrosion treatment should be carried out after welding. >>>More

You can use a single-sided door cover, do not add a set in the bathroom, and let the edge of the door cover and the tile wall in the bathroom be flush and overlapped.

Toilet waterproof leakage can not smash bricks, the use of brick-free special waterproof materials, which penetrate into the mortar layer through the tile gaps, penetrate into the inside of the mortar layer and undergo a chemical reaction, produce particulate matter that will not be dissolved, can completely block the capillary pores in the cement mortar, the capillary leakage water channel, when the product penetrates into the cement board and reacts with the chemicals in the cement, the waterproof layer will be produced, and the cement board is closely combined into a whole, with the effect of waterproofing. The method of waterproof leakage in the bathroom is: leakage on the top of the bathroom, need to find the location of the leakage, repair, the water consumption of the bathroom is very large, the ground is generally very damp, especially in the rainy season, the wall tiles fall off or there is a phenomenon of mold, at this time there will be water slowly seeping out, forming small water droplets on the roof, falling down drop by drop, you need to find the location of the leakage, and repair it.

What do you mean by "one bite"? There is no connection between the bathroom to deal with water leakage and smashing the wall, that is to say, there is no need to smash the wall at all, unless the original pipe leaks water and is buried in the wall, then it is necessary to smash the local wall, or when you want to redo the waterproof layer, you must smash the surface tile layer of the wall and the ground, and carry out the water discharge experiment (24-48 hours) after the waterproof layer is done to see if there is any leakage downstairs, if not, you can paste wall tiles and floor tiles.

It depends on whether your washbasin cabinet is a dead cabinet against the left wall or not. >>>More