The veneer on the furniture has fallen off, what glue is good?

Buy a small bucket of all-purpose glue commonly used in decoration, apply it evenly, wait for 5 to 10 minutes, and then close it.

In fact, there is a kind of glue that is very good, that is, it is specially used for sticking shoes (the kind used for sticking shoes, not the kind of 502 (remember to pay attention)), you go to repair shoes, as long as you understand, repair shoes are reliable, there should be that kind of glue (this glue is soft, not like 502, the glue is hard, and the taste is to).

The veneer on the furniture has fallen off, and it can be re-stained with 502 glue, which is fast and waterproof.

502 glue is used for porous and absorbent materials, and is used for steel, non-ferrous metals, rubber, leather, plastics, ceramics, wood, non-ferrous metals, non-metallic ceramics, glass and flexible materials such as rubber products, leather shoes, soft and hard plastics, etc. It is widely used in electrical appliances, instruments, machinery, electronics, optical instruments, medical, light industry and civil industries.

All-purpose glue. Glass glue. Three seconds.

There is a kind of wood glue for woodworking

Hello, it is recommended to use HY-308 glue on it.

When the furniture factory produces furniture, the skin on the bonding surface is made of neoprene universal adhesive, so it is best to repair the group with neoprene universal adhesive, and the use steps:

1. Use solvent to remove the parts of the furniture that need to be repaired and the residual glue on the veneer, and the beam or Xun will be smoother after repairing.

2. Use a brush or a special scraper for all-purpose glue sizing to evenly coat a layer of glue on both sides of the repair part.

3. After gluing, let it dry for 10-15min, then align and press, and then scrape the flat surface with glue to scrape the rubber from the middle of the skin to the surrounding area, drive out the air that may be in it, so that the skin is more flat, if the weather is too humid or the temperature is too low, you can use a sun lamp to irradiate it or blow it with a hair dryer and then fit, so that the bonding effect will be better.