-
Anonymous users2024-01-24Plate drilling.
This step depends on whether it is custom panel furniture or finished type, now many panel furniture on the market is not only equipped with installation instructions or fool operation, there are already drilled holes on the board, if there is no drilling, do not mess around, first use a marker pen to mark the position on the board and then prepare the required three-in-one connectors, such as: eccentric wheels, screws, embedded parts, etc., adjust the distance and then make holes in the plate.
Embedded parts are installed.
The embedded part is one of the accessories in the three-in-one connector, which is very simple, as long as the accessory is taken out separately and driven into the plate.
Eccentric wheel and screw installation.
Carefully install the eccentric wheel and screw and confirm their position; Use a screwdriver to lock the eccentric wheel and screw; Note: You can judge whether the lock is tightened according to the cross situation on the eccentric wheel, such as the "+" and "+" direction to twist the eccentric wheel is locked, and the "-" direction to twist the eccentric wheel is loose, this is common sense, I don't know if you know?
Install the screw. Carefully distinguish the AB position of the plate, such as which is the one to install the screw which is embedded in the screw, after distinguishing the AB position, install all the A plates to install the screw on the screw, first of all, tighten it by hand to a certain extent and then reinforce it with a screwdriver, and then connect the AB plate assembly together through connectors, and check whether the position is correct after the connection between the screw and the two plates.
The eccentric wheel is fixed.
The last step is to put the eccentric wheel into the hole, the position of the eccentric wheel can be correctly put into the hole, not higher than the plate nor lower than the plate, that is, the correct punching depth, according to the correct "+ direction to tighten the connector is completed.
You can also use a screwdriver to tighten the screws and then it will not be loose, the general furniture installation master knows the structure of the three-in-one screw, I don't know how to explain it to you, it is always recommended to install furniture or find the furniture installation master of the furniture installation platform of Master Wan is more reliable.
Isn't it that you didn't install it well, the most basic flat quality requirements I think they won't make mistakes, see if the rod below is not in the right position.
It mainly depends on the thickness of the board of your panel furniture, if it is relatively thick, you can punch a hole in the middle of the thickness of the board. If it is a thinner board, it is necessary to install metal edge strips on the four sides of the board to increase the thickness, and then punch holes in the middle of the edge strips. For example, the width of the edge strip is centimeters, and the hole is punched right there.
Where is the partition located?
With a variety of wood such as red beech, cherry wood and other thick solid wood veneer as wood veneer, after complex equipment flow, 160T pressure, 250 degrees high temperature will be firmly fixed on the template base, will be originally in the on-site decoration woodworking engineering and wood paint engineering, to do the finishing part of the paint, in the factory through finishing operations for production (such as: doors, door covers, window covers, baseboards, wall wood veneer modeling, wardrobes, cabinets, etc.), and then to the site for assembly.