-
Anonymous users2024-01-24When the faucet is used for a long time, it will be found that the phenomenon of water leakage, every time after use, the faucet is tightened or dripping, and the faucet is generally replaced directly, in fact, we can also use other methods to solve this problem. First of all, 1. The reason for the leakage of the water outlet: it is caused by the wear of the axial gasket in the faucet. Use pliers to loosen the gland and remove it, take out the shaft gasket with a clip, and replace it with a new shaft spacer.
2. The reason for water leakage in the lower part of the faucet: it is caused by the wear of the triangular sealing gasket in the gland. You can loosen the screws and remove the tie head, then loosen the gland and remove it, and then take out the triangular seal shop on the inside of the gland and replace it with a new one.
3. Water leakage at the joint of the pipe: Roughly the cap nut is loose, then you can re-tighten the cap nut or replace it with a new U-shaped gasket.
After knowing the above faucet leakage, it is necessary to start repairing, about the repair of faucet leakage, experts believe that the cause of water leakage is nothing more than the damage of the water-stopping tape that ties the faucet part (fixing the screw). Therefore, just remove the faucet with a plier and re-roll the new water-stop tape in the place where the fixing screws are located
1.First, tie the faucet tightly and use a wrench to turn the faucet back off in a counterclockwise fashion.
2.Turn the threaded hole outward and roll the threaded part 5-6 times along the clock with wind-stamping tape.
3.See if the faucet is adjusted and tied in the direction of the clock with water tether pliers.
4.After the installation is completed, turn on the main switch and try to confirm that there is still water leakage.
Some owners may find that the water output of the faucet is getting less and less, in fact, this is likely to be a water leakage, because the water-stop disk of the single-gun faucet is stuck in the sand, experts recommend that the owner find a professional repairer to disassemble the faucet to clean up, but if the rubber pad is damaged, it must be replaced. Generally speaking, the correct use of the faucet means not to rotate the faucet too tightly, and the faucet rubber mat can maintain the life of the year.
1. Water leakage at the water outlet: The kitchen faucet leaks, and the water leakage at the water outlet is caused by the wear of the shaft gasket in the faucet. Solution to a leak at the outlet: >>>More
The part of 3 in the figure is a screw rod downwards to put a rubber ring (to play a sealing role to prevent downward leakage), and then through the basin, there is a nylon lock nut from below to tighten, play a fixed role! You first check if the rubber ring doesn't work, and then check if there is a dew point in the screw part (some brand faucets are made of recycled materials, and the service life will not be very long)!
1 Water leakage at the water outlet.
Kitchen faucet leakage, encountering a water outlet leak, is caused by the wear of the axial gasket inside the faucet. The solution to the leakage of the water outlet: use pliers to loosen the gland and remove it, take out the axial gasket with a clip, and replace it with a new axial gasket. >>>More
The nut below is easy to loosen, loose is easy to leak, tighten it, if not, change the leather gasket. >>>More