-
Anonymous users2024-01-24It is best to do waterproofing on the wall in the bathroom, but this must remove the decorative surface of the bathroom wall, you can also try to remove the batch layer on the outer wall of the bathroom, expose the wall bricks, do permeable crystalline waterproofing, and then use polymer cement sand to block the exterior wall surface, and then redo the paint surface.
-
Anonymous users2024-01-23Answer: Pro, hello, the wall seepage treatment method outside the bathroom has the following points: 1, first to find the cause of water seepage, only to know what method to use, if it is a water pipe leakage, you need to find the location of the water leakage, if the waterproof is not done to cause water seepage, you must do a good job of wall waterproofing.
2. If it is water seepage caused by the rupture of the water pipe, you need to cut the bricks to find the location of the water pipe joint, you can see if the joint is leaking, replace the water pipe, and then restore the wall bricks.
3. If the waterproof layer is leaking, the bricks on the surface should be shoveled off, and after finding the leakage, it should be smoothed with a plugging treasure and then coated with waterproof coating. If it is caused by insufficient height, it is necessary to plane the tiles at the height, redo the wall, and then paste the tiles.
This is a problem with the gasket of the drain, it is best to remove it and install it from the new, do not try to use the plugging thing to plug the surroundings, so that it will leak downstairs after a long time
First, it stands to reason that there should be no problem with re-playing silicone zhi for sealing. If it is said that it is not broken and it is a bad tile, it seems that there is no other better way than glue and seal. >>>More
Bathroom floor waterproof is not done, water leakage directly downstairs, if there is obvious leakage, you can check whether there are cracks, the solution can be waterproof from both sides, one from the bathroom to find the leakage point, dig up and reuse the K11 series of waterproof direct brushing, the second if there are cracks, and do not want to lift the bricks, you can block from downstairs, find the crack with high-pressure grouting plugging, the periphery with a water-stopping needle into the crack half deep, with high-pressure grouting machine grouting can be. >>>More
1. First of all, knock out all the floor tiles and wall tiles about 30cm in the lower part of the wall. (Note: Knock before you knock.) >>>More
Is there a bathtub, if there is a bathtub, most of them are problems under the bathtub, many people encounter this problem, and finally smash the bathtub, and then redo the ground to waterproof, and then change it to a shower partition or shower room.