-
Anonymous users2024-01-24The small thin pipe inside the toilet bowl is backwater. The flush toilet consists of the following main parts: inlet pipe, outlet pipe, seepage pipe, water plug (inlet and outlet), float, drain knob and lever, water refill mechanism, water tank, urinal (the urinal has a bend that connects to the water tank).
-
Anonymous users2024-01-23Flush toilet bai inside that.
The small duke is backwatered. The flush toilet is composed of the following main parts: the inlet pipe, the outlet pipe, and the right.
Seepage pipes, plugs (inlet and outlet), floats, discharge knobs and levers, water replenishment mechanisms, water tanks, urinals (urinals have elbows that connect to the water tank).
The basic principle of the flush toilet is to use the gravity of the water to convert the potential energy of the water into the kinetic energy of the water, so as to carry the excrement into the sewer pipe. Toilet flushing methods are divided into direct flush type, rotary siphon type, vortex siphon type, and jet siphon type; The water pressing method can be divided into flush down type, siphon flush down type and siphon whirlpool type.
The toilet is a passage for excreting dirt and something we have to use every day. If you don't do a good job of cleaning, it is likely to become the culprit of the threat to your health, because it is easy to breed bacteria, and cleaning the toilet bowl in daily life is actually a relatively simple thing.
-
Anonymous users2024-01-22The inlet pipe of the tank. By working the principle can be very.
Good understanding of the role.
Toilet Tank Back Working Principle:
The working principle of the flush toilet is roughly around the main components, that is, after the toilet is used, the waterproof button on the water tank will be pressed, and the button will pull up the water plug through the lever, at this time, the water in the water tank will flow out, when the water in the water tank is discharged, the outlet plug will automatically fall, so as to block the water outlet, and then the float will be driven by the lever to pull the water plug up because the water level in the tank drops, so that the water can enter the water tank.
-
Anonymous users2024-01-21This pipe is the water supply pipe on the water inlet valve, which is inserted into the overflow pipe of the drain valve, which is the drain valve in the middle of the toilet tank.
-
Anonymous users2024-01-20It must have been that the small pipe was still in the bend of the toilet bowl and did not go down. You'd better get a sewer to clean it up for you.
-
Anonymous users2024-01-19The small hill in the toilet is backwater. The flush toilet is composed of the following main parts: inlet pipe, outlet pipe, seepage pipe, water plug (inlet and outlet), float, water discharge knob and lever, water refill mechanism, water tank, urinal (the urinal has a bend connecting to the water tank).
The white plastic knob on the left side is used to adjust the height of the float, the higher the float, the more water can be stored, but if it is too high, it will overflow and flow into the toilet.
You can use toilet cleaner to remove, but I think it's better to use dilute hydrochloric acid, dilute hydrochloric acid into the toilet bowl some, cover the lid and soak for a while, the hydrochloric acid will quickly corrode away the stubborn stains, and then scrub with a brush and wash with water, so that the toilet bowl will become very white. However, when using hydrochloric acid, you must be careful not to get hydrochloric acid on your skin and clothing, and it is best to wear rubber gloves for protection.
This should be the PPR water pipe, whether this is the inlet pipe or the outlet pipe for you to observe on site.
There is a germicidal disinfectant, which is blue. Perhaps, this is what your toilet in your house looks like.
Now the labor cost is so high! Why don't you do it yourself, in fact, it is not difficult at all, just buy the same model of accessories and replace them.