How thick the steel bar is required for prefabricated kitchen panels

Don't worry too much about whether it will collapse or not, because the houses are all super-static structures, and they form the whole of the space. However, some places may lose their bearing capacity or deflect too much, resulting in cracking is very troublesome, and this hidden danger is the most worrying headache! >>>More

Like the buildings built in the past few years, especially the kind of small high-rise with elevators, it is impossible to be prefabricated panels, they must be cast-in-place reinforced concrete, and your cracks may be cracks in the wall that have not been approved during the later decoration or the building is a layer of plastering outside the cast-in-place cement.

It's hard to generalize. If you look at the shock absorption manual and other materials, even if it falls, the safety system of the kitchen and bathroom is relatively high; People lying in the kitchen and bathroom will also have a higher chance of survival. As an additional note, the kitchen here must be an original design kitchen, and if it is a kitchen moved to a balcony, shade, or storage room, it is a different matter. >>>More

It is not possible to lay a brick wall on a prefabricated hollow core slab, there is no beam bracket underneath, you can consider a lightweight board or infill wall, which is lighter in weight. It can be raised 40 cm, and the drainage pipe goes to the outer wall, pay attention to waterproofingwith a water repellent agent. First use waterproofing agent mixed with cement mortar to do it at the base of the bathroom, and after it is dry, then use waterproofing agent mixed with cement ash to brush a layer on the surface of the first time. >>>More

The top latex paint is mostly used in caisson ceilings and original top decoration. The operation is divided into three steps: bottom treatment, re-brushing, sealing and priming, and topcoating. The order of operation is as follows: >>>More