-
Anonymous users2024-01-24Can be fixed. 1. Clean up the glue in the original veneer with an abrasive cloth or a small iron file, and then use all-purpose glue (preferably sticky fireproof board) or milky white glue and wood glue powder (but the effect is slower) to pay attention to not too much, cool and dry for about 1 minute after brushing, and then glue, gently knock or press with a heavy object, keep it for a certain time, and it is done.
2. Pour the milky white glue into the open part, and then press it with something, focused. Or you can use a clip card, wipe the glue pressed out from the outside, and take it off after 24 hours.
3. Do not use 502, it will be hard and deformed.
-
Anonymous users2024-01-23It doesn't matter if it's on, the most important thing is to find out why it's on. I am He Ye of the shark, we do not discuss the glue problem, you mainly look at the operation of the puzzle at that time to see if there are any of the following problems. Whether the splicing glue is selected correctly, whether the wood splicing surface is smooth, the moisture content of the wood (8-12%), and the main solid ratio (100:
10-15), active period (used up within 45 minutes), cloth glue amount (300g square), opening time (pressurized within 3 minutes), pressurized pressure, pressing time (45-120 minutes depending on wood hardness), health time (8 hours).
-
Anonymous users2024-01-22(1) If the drying effect of the wood is not good, it will cause the problem of high moisture content of the wood after moisture regain and the internal stress of the wood cannot be eliminated. For example, the sapwood and heartwood parts of wood are more likely to exist in this area.
2) If the wood is not stored properly, it causes serious moisture absorption at the end. Such a lumber panel end will have a more uniform length of glue opening.
3) If there is a phenomenon of wood cracking and glue opening at the end of the puzzle at the same time, it is because the wood has been caused by internal cracks in the drying process.
4) If two or three layers of composite wood are used for paneling, it should be noted that the high moisture content of composite wood causes stress caused by the shrinkage and deformation of wood fibers during dehydration in the later stage, resulting in cracking along the finger interface of the panel.
-
Anonymous users2024-01-21Either there is a problem with the board, or there is a problem with the glue, or there is a problem with the operation.
Add the plaster powder to the latex, then smooth it with a spatula, smooth it with sandpaper until it dries, and brush it with the same paint as the furniture!
If you don't stick to those disgusting things, if you can't turn on your phone at that time, then you take out the battery and dry it naturally (don't blow it with a hair dryer) and then pack it in a fresh-keeping bag, drill a few small holes in the bag, and put it in a rice bowl or an absorbent environment. More than 24 hours to boot and try again. It cannot be turned on during this period.
Dampness is mainly caused by moisture, and the main purpose is to target moisture, and now there are two aspects to moisture: >>>More
Remove the stain with toothpaste, then wipe the whole piece of furniture with a wrung out damp cloth, dry the cloth for about an hour, spray it with a special spray such as "Bi Lizhu" and then wipe it with a soft cotton cloth.
How to deal with water or moisture in furniture:
1. After solid wood furniture enters water or is damp, it should first remove water stains and mildew spots on the furniture with water or mild cleaning agent, and then use dehumidification equipment (air conditioning at home can) to gently blow into the water or damp part. Finally, gently wipe it off with a cotton cloth or a soft, dry towel. >>>More