-
Here are a few steps:
1. Turn off the power.
2. Connect the live wire to a bolt hole in the lamp head.
3. Wiring from another bolt hole of the lamp head to a bolt hole 4 of the switch, and then wiring from another bolt hole of the switch, and finally connecting to the zero line 5, closing the power switch test.
-
It's very simple, one end is connected to the live wire, and the other is connected to the live wire of the lamp. It can be wired as shown below.
The specific connection method is as follows: there are three terminals on the switch. When looking at the opposite side of two switches in the same direction, the three terminals are numbered from top to bottom. >>>More
Theoretically, the live wire (red wire) is required to be connected to one end of the switch first, and the other end of the switch is connected to the binding post in the center of the lamp head. >>>More
The neutral wire enters the switch, and the live wire enters the lamp head. Then connect the other end of the switch with the other end of the lamp head, and it's OK.
The owner of the small shop must not understand the principle of switching. >>>More
There are two terminals in the switch, one end is connected to the bulb and the other end is connected to the live wire! The neutral line is connected directly to the bulb!