-
Anonymous users2024-01-24It's very simple, cancel the gasket above, buy glass glue, replace the gasket with glass glue, use glass glue up and down, operation method: remove the pool water, dry, don't have the gasket on it, don't have dirty things, and then the upper and lower interfaces are made with glass glue, put it on and tighten it, and the extruded glass glue is smoothed by hand, and it is easy to use after waiting for drying, it can be used for 24 hours, but do not touch it hard; Because it's not completely solidified yet.
Precautions: Confirm that the glass glue is dry before playing, and do not use water immediately after beating.
Guaranteed to work!!
-
Anonymous users2024-01-23The stainless steel drain and your basin do not match, it stands to reason that the bottom of the pool and the lid of the stainless steel drain should be flat, and there will be no water storage. I estimate that your stainless steel drain diameter is larger than the basin drain diameter, causing the stainless steel drain cover to extend beyond the basin floor and directly cause water leakage.
-
Anonymous users2024-01-22First of all, check whether there is a problem with the installation of the interface. If there is no problem, check the basin again for "trachoma".
The porcelain basin I originally bought had this problem, and finally found that there was a "sand hole" at the bottom of the basin, which could be replaced.
-
Anonymous users2024-01-21The sewer pipe is not not already rubber, if it is, the rubber can be used underneath.
I bought this.
1. The reason for the leakage of the kitchen sink drain pipe. >>>More
Go buy a special hose belt, the kind that costs one yuan, and wrap it around the interface until it can be connected tightly.
It is difficult to achieve, if it is an instantaneous electric water heater, there is a risk of short circuit if it is installed under the basin, and if it is gas, there is definitely not enough space because of the flue to be installed, so it is recommended not to try it, I hope this answer will help you.
1. Causes of kitchen sewer pipe leakage.
To solve the problem of water pipe leakage maintenance, you must first find the cause of the water leakage, and here are some of the listed ways to deal with water pipe leakage. If the water pipe is leaking, you must first find out which part of the water pipe is leaking, and the part where there is more water pipe leakage is usually the sewer pipe, water pipe joints and other places. The treatment methods for water leakage in different parts are: >>>More
It can be pretended like this. However, the upper edge of this basin is not the same as that of the undercounter basin, and the edge of the undercounter basin is narrow and flat, and the bonding is easy. Your basin is an ordinary basin with a decorative structure on it, with a large width and depth, which is not very good to use as an undercounter basin.