How many meters should the toilet be installed from the wall

1. Before choosing a toilet on the market, first determine the size of the water in the seat (i.e., the distance from wall to wall). Before installation, please make sure that the product accessories you choose, completed, please carefully review this manual and learn about some products.

2. Determine the height of the drain according to the condition of the toilet and cut off the rest of the part. The goal is to make the plumbing and toilet bottom more consistent. Start by using a hacksaw or cornea for the sewer according to the horizontal height of the centimeter, because the flange of the toilet bowl is soft.

If it is not centimeters high, there may be water seepage problems, and centimeters are more tightly fitted.

3. Measure the pit distance. Before choosing a toilet, first determine the size of the water inside the house, that is, the distance from the wall to the water. When using a toilet, if you want to decorate the tiles, you must measure the pit distance after applying the tiles. Otherwise, the toilet will be bought back and cannot be installed.

4. Install the flange ring provided with the toilet at the drain. Remember to press hard to ensure the compaction of the flange ring and toilet drain. Place the flange on the toilet drain.

Then carefully align the lower hose and lower it smoothly. At this point, the wall of the sewer pipe is inserted into the viscous clay of the flange for sealing.

5. After the water test is completed, start to install the cover.

6. Glue around the toilet, this step is also very important, not only to stabilize the toilet, but also to prevent the smell of the net from being released from the toilet. Therefore, we will not only fight, but also four whole weeks. At the intersection of the toilet bowl and the outer surface of the floor, since the toilet bowl and the floor are not one, a joint seal transparent sealant can be used for agitation, and the outer opening of the toilet bowl is sealed to maintain the integrity of the floor.

Some bathroom water can clog around the toilet bowl. NOTE: IF YOU NEED TO INSTALL THE SET SCREWS, FIRST APPLY A SPECIAL SEALANT INSTALLED IN THE TOILET BOWL EVENLY ON THE OUTSIDE 2CM OF THE TOILET BASE.

The drain of the toilet bowl should be pulled towards the center of the drain. Expansion bolts are located on the left and right sides of the toilet, remove the toilet, punch holes and raised bolts.

7. Install or debug the water tank accessories.

8. After installing the toilet, wait until the glass glue (putty) or cement mortar has solidified before releasing water. The curing time is usually 24 hours.

Before the toilet is installed, it is necessary to reserve the space on both sides of the toilet to ensure that people can do it normally on the toilet without feeling that the space is too small and too crowded;

Generally speaking, the distance between the two sides of the toilet is reserved for people to sit, the minimum is 75cm, and this distance is just right for people to sit on it, and there will be no feeling of congestion;

How much is the specific wall of the toilet installation, this is the problem of the pit distance of the toilet, and the pit spacing of the conventional toilet is 30cm and 40cm. Normally, if the error is less than 3cm, it can be installed and used normally.

400MM is generally like this, but you have to go to the actual measurement, there will be errors.

The center distance of the toilet is generally 30cm or 40cm, which refers to the distance between the side of the toilet drain pipe and the back wall. But there are special ones. Therefore, when installing the drainage pipe, 32cm or 42cm center distance is generally reserved for the sewage nozzle, and the other 2cm is left for the veneer brick.

Hope it can be adopted, thank you!