The moldy crevices of the bathroom glass glue are covered with mold, how to clean it easily and prev

Will your bathroom glass glue be moldy if it is permanent? Is it that even the crevices are covered with mold that makes you feel sick even when you look at it? If so, clean it up quickly!

StillLife is full of small tricks that can help you quickly and easily remove mold and bacteria and prevent regrowth!

When you see that the glass glue at home is moldy, is the first thing you think of is to remove the moldy glue and then apply a new layer of glass glue? This method is indeed effective, but it is a bit crude, and this method treats the symptoms but not the root cause, because after a long time, the new glass glue will still be moldy, and then you will have to repeat the glue change. In fact, we can do without this less efficient method and just use bleach.

Bleach is inexpensive, but it has an excellent sterilization and mildew removal effect, you only need to dissolve the appropriate amount of bleach in water, dip a brush in bleach solution, and then gently brush the moldy and blackened glass glue, you can quickly remove the mold 。However, you need to note that because bleach has great instability, especially when exposed to light, it will decompose quickly, so after preparing the bleach solution, you need to use it immediately, otherwise, after a long time, the effect may not be obvious.

In addition, it is necessary toPay attention to the concentration of bleach solution, too much concentration will damage the glass glue, and may cause damage to the human body; If the concentration is too small, it may not be effective. If you can wear rubber gloves, it is more safe to keep your skin from direct contact with bleach. There are many small tricks for sterilization and mildew removal in daily life, and there are some special bathroom sterilization and mildew removers on the market, and the effect is also quite good If you are interested, you can give it a try!

It can be diluted with bleach and water, then dipped in water and brushed with a small brush.

You can blow it with a hair dryer or use a syringe without a needle to suck up the dust in the gaps.

If it's really full of mold, then I think you should put more vinegar.

Moldy glass glue like this can be brushed with white vinegar baking soda.

First of all, clean him, and then make up it again with a sewing agent.

Bleach can be used for mold treatment.

Then you'd better clean it up and do it all over again.