How to do bathroom waterproofing need those materials

1.What materials do you need to make a bathroom waterproof?

1.There are a lot of materials that need to be prepared. First of all, you need to prepare all kinds of tools, brushes, scrapers, protective films, etc.

Secondly, it is necessary to prepare waterproof coating, which is generally in barrels. You can buy a few more barrels. Specifically, it can be considered in combination with the area of the bathroom.

Both the walls and the floor need to be brushed, and it is best to brush 2 or 3 layers, so that the waterproof layer will be more complete.

2.Once the material is ready, the floor needs to be cleaned and the first layer of waterproofing paint begins. You can use a brush dipped in waterproof paint to brush evenly and keep the thickness consistent. Check at any time when brushing to see if there are cracks, blisters, or falling off.

After brushing, wait for it to solidify for about 4 to 6 hours. When it is completely solidified, you can brush the second layer. The interval between them should not be too short, otherwise the waterproof effect will be greatly reduced.

3.When the second layer is dry, a protective film should be spread on the ground. The protective film should cover every corner and ensure a perfect fit.

4.The final step is to do a closed water test. First, plug the floor drain, then turn on the faucet to drain the water. The water level must not be lower than two centimeters, and the test time is at least 24 hours, all 48 hours. This can be considered in the context of the actual situation.

5.When the time comes, check if the water level in the bathroom has dropped, and go downstairs to the neighbor's house to see if there is any leakage in the ceiling of their house.

Regarding the waterproofing of the bathroom, I can give you the following suggestions::

1.The first thing to pay attention to when doing waterproofing in the bathroom is the choice of waterproof materials, and it is recommended that you can directly use the waterproof slurry in the kitchen and bathroom, which is specially developed for the yin and yang angles that are easy to seep into the kitchen and bathroom, wear pipes, sanitary ware, floor drain peripherals, etc., so the special materials are dedicated, the pertinence is stronger, and the waterproof effect is of course better.

2.The construction of waterproofing should be carried out in accordance with the requirements of the manual, the proportion of waterproof materials, the standard thickness and height of construction, etc., so as to ensure a good waterproof effect.

3.After doing a good job of waterproofing, it is necessary to do a good job of sprinkling and maintenance in the later stage, and places with direct sunlight need to be covered and covered.

4.The base surface before waterproofing must be cleaned, there can be no oil and dust, etc., and it must be sprinkled with water to moisten, but there must be no stagnant water.

5.After the waterproofing is completed, remember to do a 48-72 hour closed water test to check whether there are any leaks in the waterproof construction and whether the waterproof function is normal.