-
It should be installed, and this responsibility should be requested by the property maintenance company to assist in the installation. The property company pays the money, and the maintenance unit provides technical support.
However, in practice, problems are often encountered, such as the lampshade is often damaged, the responsible person cannot be found, the property cannot approve the payment, the installation is shelved, and it is also possible that the lampshade is temporarily out of stock, and the maintenance unit needs to purchase, and there is a gap here.
To solve specific problems, it is recommended to consult the property and urge the property to install the lampshade as soon as possible.
-
Go to the property, and the property will take care of it.
-
These things should go to the property, and the property will take care of it.
There is no picture, generally the light box on the ceiling is soft film, the lamp is about 100 yuan per square meter, and the soft film is about 100 yuan.
The light box board is a translucent material of plexiglass or acrylic, which has the effect of transmitting light, but the appearance is cloudy and outdated. It is recommended to use frosted glass or higher-grade craft glass.
The best thickness is 5mm, but there is a difficulty, that is, it is difficult to meet your requirements for the whole sheet, because the normal specification of the board is, unless you splic, if you want not to splic, the whole sheet, only to the plate factory custom, of course, the price cost is quite high, such as the character ratio is high, and do not want to fight, then choose the thickness of 3mm, because such a thickness of the plate is a large plate. Or of course, the effect is not so strong. Sincerely, >>>More
The wire should be threaded into the insulating sleeve and the strength should be separated. IF THERE IS NO CEILING ON THE CEILING, ASK THE ELECTRICIAN TO OPEN A 20 10MM FINE GROOVE ON THE CEILING UNTIL THE POSITION WHERE YOU WANT TO INSTALL THE LAMP, AND THEN PRE-EMBED 2 LIGHTING LINES, AND THEN ASK THE PAINTER TO FILL IT.
It can be changed, and the following needs to be noted:
1.The weight of the downlight is relatively light, so the ceiling in this position should not be reinforced; >>>More