I want to install a shower in my bathroom, how should I install it?

1. Installation tools: a set of shower sets; Large wrench, pliers, hexagonal wrench, electric drill, screwdriver.

Second, the installation steps and methods:

1. After wrapping the two elbow joints around the raw meal belt, use a movable wrench to tighten them on the water outlet joints in the two installation holes on the wall, and ensure that the center distance of the two elbow joints is 150mm after tightening.

2. Put the two decorative covers on the elbow joint.

3. Stuff the mounting washer into the elbow joint, and use a wrench to tighten the mounting nut on the two elbow joints to fix the faucet on the wall.

4. At a distance of about "H" from the faucet water outlet, drill three holes with a diameter of 6mm and a depth of 35mm.

5. Insert the expansion pipe into the installation hole, and fix the wall seat to the wall with self-tapping screws. Note: The wall base must be on the same centerline as the faucet spout.

6. Wrap the faucet with a cloth before drilling to avoid the faucet being soiled and bruised.

7. The height "H" needs to be determined according to the actual product during the actual installation.

8. Plug the sealing ring into the lower end of the switching valve.

9. Screw the lower end of the switch valve and the upper end of the faucet through threads.

10. Wrap the faucet with a cloth before drilling to avoid the faucet being soiled and bruised, and pay attention not to damage the electroplating surface when using a wrench to tighten it.

11. Screw one end of the shower rod and one end of the switch valve through threads (the end of the column shower rod must be equipped with a sealing ring).

12. Then put the decorative cover into the other end of the shower rod, then insert that end into the wall base, lock it with three set screws respectively at this end, and finally push the decorative cover to the wall.

13. After installation, turn on the water inlet switch and rinse the pipeline thoroughly.

14. Connect the nut end of the shower hose with the joint behind the switch valve body, and insert the nut with one end of the hand-held shower and insert it into the shower seat (Note: the two ends of the shower hose must be equipped with washers.)

15. Screw the top spray onto the shower rod.

You don't need to damage the wall, you buy a shower, and then add a pair of surface-mounted seats, which most workers will install.

I haven't really seen you yet. I've been doing hydropower for so many years, and I can see that your home is like this, and you can't buy what you want in the market. There's really no way to break the wall. I can only make all the pipes open

It's hard to find. Despise developers.