-
Anonymous users2024-01-24The steps for measuring the size of the common toilet partition are as follows:
1. To measure the total length, the first thing is to record the total length.
>2. Measure the total width (depth) and record the depth.
>3. Measure the depth plate and record the position of the support feet that need to be installed.
>4. Measure the squatting positions and determine the width of each squatting position.
> this is how the size of the toilet partition is measured.
-
Anonymous users2024-01-23The size of the public toilet partition is calculated in square meters (extension meter multiplied by height = area).
-
Anonymous users2024-01-22Count from the middle, half on each side.
-
Anonymous users2024-01-21There's no set algorithm depending on how you design it.
-
Anonymous users2024-01-20Refer to the gallery! There are specialized atlases.
-
Anonymous users2024-01-19It is usually a measurement of the width.
The height is calculated from the supporting foot, the height.
Or support the feet, according to the hardware accessories final accounting.
FYI.
-
Anonymous users2024-01-18What kind of partition is it?
The size of the public toilet partition is calculated in square meters (extension meter multiplied by height = area).
The formula for area in square is: (length + width) x height. Hope it helps.
The standard size of the sanitary partition is general, and the standard of the sanitary partition is 900 (W) 1520 (D) 2000 (H), but the actual size can be changed flexibly, and the size can be appropriately enlarged or smallened, but the design should be considered taking into account the different human body types, and the minimum size of the general sanitary partition cannot be less than meters. Because now ??The bathroom is not only used for convenience, many people still tidy up their grooming in it, so if the size of the toilet partition is too small, it is very inconvenient.
Our living conditions are very good now, so there are many changes in all aspects of life. For our bathrooms, most of us use our partitions to block our space. Make better use of our restrooms. >>>More
We also have to understand according to our construction, but such a size also depends on the construction situation on site. So we also have to think about the back aspect. The higher partition door is about 2m, and the partition floor of the bathroom should be made of waterproof, dirt-resistant, non-slip granite, etc., and its height size should be 10-20mm lower than that of other grounds. >>>More