-
Anonymous users2024-01-24Walk the wall to drain only a few wall tiles The loss is not big, you can buy a few more bricks and paste them, generally only one brick can be broken, and the rest can be picked up with tools.
-
Anonymous users2024-01-23Call the plumber over. If it's not very far from the previous drain, just walk a pipe through the ground.
There are often three reasons for the smell of the washbasin: first, the basin drain pipe is not an anti-odor pipe; Second, there is no S trap in the sewer pipe; Third, the sewer pipe and sewer mouth are not tightly sealed. Therefore, we can start from these three aspects when we inspect the wash basin. >>>More
For the problem of no water in the basement, it is generally solved by a sewage lifter, such as a common basement bathroom, we can solve it through a toilet sewage lifter like microboy. This solution has the following advantages: the first is the low cost of civil construction. >>>More
How to prevent moisture in the bathroom without windows 1. Waterproof aluminum foil blocks condensation According to our usual bathing experience, we will find that the basin or faucet in the bathroom will produce a large amount of condensation when it encounters heat, which will flow into the bottom of the cabinet along the countertop, causing the cabinet to become mildew. If you can add a layer of waterproof aluminum foil or rubber pad to the bottom of the cabinet in time, you can solve this problem, and you can fix the bath products while preventing moisture. 2. Drying and dehumidifying bath bombs In addition to drying the stagnant water in the bathroom in time after each wash to eliminate moisture, you should also try to give full play to the function of bath bombs. >>>More
Not a plumbing problem? That is the floor drain problem, the washbasin is generally used to wash our hair sometimes, it is normal to be blocked by the hair, and it is okay to clean it up.
1. See if the sewer pipe is broken, if it is a PVC water pipe, you can buy a PVC water pipe to connect it yourself, first cut the broken pipe, put the interface into one end of the pipe first, so that the cutting position of the other end is just flush with the other mouth of the interface, so that it can just be straightened, and then send it directly to this end, so that both ends have a certain cross distance (length) and then disassemble it. Apply PVC glue to the inside of the two ends and the outside of the two sewer pipes, and then apply it to the pipe according to the above method. >>>More