-
Anonymous users2024-01-24There is a cover in the water tank, when you press the flush switch, it will open, and then there is water pressure to buckle it again, it is estimated that your water tank is a problem with this place, check it, put the lid back on, and it should be solved.
-
Anonymous users2024-01-23First, the point spring on the water tank fails, resulting in pressing the point on the switch for a long time, take off the water tank cover, the water will not flow, it is this problem, find the spring in the water tank and install it, if the water tank cover is taken down or continue to leak, check whether the sealing ring at the bottom of the water tank is deformed, manually let it return to its position, if the rubber ring is fine, check whether the valve in the middle of the water part is falling due to water rust, and press the switch repeatedly by hand to see if the valve is returned after opening If it cannot be solved after the experiment Then close the angle valve, remove the water parts, go to the plumbing store to buy a one of the same size, and come back and install it, or you can call the after-sales phone of the toilet to replace it for you.
-
Anonymous users2024-01-22The drain inside is broken, and you can see it when you open the lid on it.
-
Anonymous users2024-01-21The simplest thing is to turn off the switch when the water is full, and the most problematic thing is to change it, because it will be unclear for a while what you say is the problem.
This belongs to mechanical failure, that is, the accessories in the tank are not flexible caused by the activity, mainly to see whether the model of the accessories and the internal installation structure have friction with each other, adjust it, most of the plugged chains are short or the float (float) of the water valve has the phenomenon of the card owner, you will see it if you look carefully, try to see if you can't send the picture inside the water tank, it is good to analyze, in view of the limited number of answers to questions and supplementary answers, you can contact in a private message
1 may be the middle of the switch leakage, that is, you press the flush that, you see the leakage inside, if not, it is through a pipe of the blue one with a ticket that, you can turn the plastic screw, let the float down, generally my experience is that the middle of the leakage, you turn it off, with a Phillips screwdriver cow tight screws.
If not, you can only go to the hardware and building materials store to buy a better water inlet assembly I hope it can help you.
Directly remove the water-stopping rubber ring to achieve the effect of draining water. >>>More
Yes, because it doesn't float, so, the outlet below is not blocked, and you can lift it up with your hands to see.