-
Anonymous users2024-01-24Obviously, the valve at the outlet is not closed properly, and the water flows as much as it enters, of course it can't be filled!
You try to press those two buttons at the same time, just hear the sound of popping, and you can store and drain the water normally
Close the triangle valve, turn the hexagonal nut of the water inlet pipe counterclockwise to remove it, and tighten it clockwise when replacing it.
Using gravity, the water balloon in the toilet bowl is originally designed according to the water pressure of the tap water, and if you switch to a bucket, you have to create the pressure yourself. >>>More
The water inlet hose is leaking because it has been used for a long time, and it is enough to tighten it with a wrench.
Wipe to see if the angle valve is open, if it has been opened, it may be that the filter screen of the water valve is plugged, close the angle valve and open the connecting hose, take off the filter at the inlet of the water valve to clean it, and then install it back in place, try to ---
The water valve is very well installed, remove the heel on the valve screwdriver, take off the flat gasket, insert the water valve from the small round hole of the water tank and hold it with your hand to find a good direction, do not let the float and other accessories in the box have contact with each other, find the flat gasket with the other hand and put it on the thread buckle of the water valve, tighten the thread with the mother on the water tank, connect the hose to the water inlet pipe mouth of the valve, and connect the angle valve at the other end.