-
Anonymous users2024-01-24Hello. Generally, the bathroom floor waterproofing is only done once, the premise is that to choose high-quality waterproof membranes and waterproof coatings, you can search for the top ten waterproof brands on the Internet, and then confirm it on the building materials market. The waterproofing membrane is better to choose high-quality and expensive ones, not to be cheap.
Because once there is a leak due to the use of inferior waterproofing membrane, it has to be re-waterproofed, which can also cause conflicts between the upper and lower floors.
-
Anonymous users2024-01-23Home improvement waterproofing is generally only done once, but it is only brushed twice at a time, and the waterproofing will generally not leak in this way. Because it is to make the bathroom waterproof, considering that there is a shower, you must pay attention to the height of the painting. Ruibol waterproof is waterproof by Hongyuan. Healthy.
In principle, the waterproof layer on the waterproof bathroom wall should not be less than meters, and from the perspective of moisture-proof, it is best to do wall waterproofing in the shower room or toilet. The installation position of the power switch should be designed in advance, and should not be installed behind the door, which is inconvenient to use; The power socket is 30 cm above the ground, and the switch is 30 meters above the ground. Cement can not be used after 3 months of factory life, and cement of different varieties and grades cannot be mixed. >>>More
MAKE 1800MM FOR THE SHOWER WALL, AND 1200MM FOR THE OTHER WALLS.
Do waterproofing needs to be done on the surface of the water, dig excellent permeability crystalline waterproofing, you can do it yourself on the cement surface with a super permeable waterproof guard (if there are cracks and potholes on the cement surface, fill the complete with metin porcelain glue and then do waterproofing). >>>More
It is a very important process to do toilet waterproofing, and waterproof construction should be coated with waterproof waterproof The performance of waterproof materials should meet the provisions of the current national standards, and there should be a product qualification certificate; The surface of the base should be smooth, and there should be no defects such as hollowing, sanding, cracking, etc., and the moisture content of the base should meet the construction requirements of waterproof materials; THE WATERPROOF LAYER SHOULD EXTEND FROM THE GROUND TO THE WALL, 250MM HIGHER THAN THE GROUND, AND THE HEIGHT OF THE WATERPROOF LAYER ON THE WALL OF THE BATHROOM NEAR THE SHOWER HEAD SHALL NOT BE LESS THAN 1800MM; THE WATERPROOF LAYER OF THE COATING FILM IS EVENLY BRUSHED, THE GENERAL THICKNESS SHALL NOT BE LESS THAN 1 5MM, THE WATERPROOF SURFACE OF THE COATING FILM IS NOT BLISTERING, NOT FLOWING, SMOOTH AND CONVEX, AND THE JOINTS OF PIPE FITTINGS, SANITARY WARE FEET, FLOOR DRAINS, AND DRAINAGE OUTLETS ARE TIGHT, AND THE END IS SMOOTH AND DOES NOT LEAK After the waterproof project is completed, it is necessary to do a 24-hour water storage experiment. >>>More
1. The waterproofing of the bathroom generally needs to be brushed 2-3 times. >>>More