-
Anonymous users2024-01-23Ask a professional to repair it, and if you do it yourself, be sure to turn off the water valve first (it is not recommended to get it yourself).
-
Anonymous users2024-01-22Plastic. Wood has the value of repair. Let's just change it to a new one!
-
Anonymous users2024-01-21It's hard to say! You better turn off the water first, don't waste it first!
Close the water inlet valve first, then remove the faucet handle, then take a wrench to remove the nut, and then remove the valve core and shaft of the faucet, and the washer screw is loose, you can drip lubricating oil to solve it, if the screw and valve core are damaged, you should replace it with a new one, and finally install the faucet back.
On the opposite side of the cylindrical handle, there is a small lid (some are hot and cold indicators), pry open and there is a small hole, put the handle on, and then use a small screwdriver (some are Allen wrenches) to tighten the screws inside, and it will not fall off.
The nut below is easy to loosen, loose is easy to leak, tighten it, if not, change the leather gasket. >>>More
The kitchen faucet replacement process is as follows.
1. Find the main valve of your water pipe and turn it off. 2. Buy a faucet with the same number as your faucet. 3. Directly remove the broken faucet, and it is best to wrap it slightly with hemp rope at the screw mouth to prevent water leakage. >>>More
Change a new faucet, it should be the valve core rubber mat is aging, if you have strong hands-on ability, you can go to the same valve core and replace it, but this is likely to still have problems! So it is advisable to replace the whole faucet!