-
The line is too long and the loss is large, the power of the electric drill is large, and the voltage drop is large, and the parallel capacitor will be better, and it will be fine after playing.
-
Your light switch is on the neutral line, and it will be like that at home with a high-power inductive device!
-
The place where the line has a problem with the joint is loose.
-
The electricity is used a lot, and the voltage is unstable.
-
It may have knocked out the thread a little and the contact was not working.
-
Don't be afraid of the cause of voltage instability.
-
At least I've been in a similar situation! Nothing! It won't flash when it's done, right?
-
The voltage is unstable and the electricity consumption is too large.
-
The voltage is unstable and the power of the electric drill is high.
It's going to break! After punching the hole, the hole should be sealed again!
The toilet is equipped with an electric drill for the shower, generally with a maximum of two eyes, and the screws can be tightened.
Yes, but the drill bit needs to buy a special tile drill bit, if you use a regular drill bit, it will drill the tile.
It is not good to use cement.
It's better to use glue. Sealants work better than cement. >>>More
You can use a battery voice-activated light, but it is best to contact the seller or Taobao directly for the matching battery.