The phone fell into the toilet, and then I fished it out, can I still use it?

Unplug the phone battery, and then send it to the local mobile phone manufacturer's after-sales service for maintenance.

They will tell you the results, and if the repair cost is more than half of the value of the phone, it is advisable to get a new one.

First of all, don't panic, we divide the situation into 3 types:

1. Drop into clean water when the power is on;

2. In the case of power failure, it falls into non-corrosive liquid;

3. Fall into non-clean water when energized, or corrosive liquid or viscous liquid or other unclean liquid regardless of whether it is energized or not.

The following recommendations are available for each situation:

1. Drop into clean water when the power is on, this situation generally does not need to be disassembled.

1.Turn off the power as soon as possible.

2.Shake it dry, but don't shake the machine off, the idea is to shake the water out of the screen. If there are water droplets left on the screen, there will be traces after drying.

3.Place under a slight heat source such as a desk lamp or spotlight to let the moisture slowly dissipate. This process takes more than six hours. Do not use a strong heat source such as a hair dryer in a hurry. Blow it and it's over.

After these three steps of processing, the power supply can basically work normally.

2. Drop into non-corrosive liquid in the case of power failure.

1.Shake it dry, but don't shake it off.

2.If there is no trace on the LCD screen, it shall be processed according to Article 3 of the first point.

3.If there is something left on the screen and it is very serious, do not deal with it according to point 1, paragraph 3, because although the electronic circuit can work normally, the screen may be quite ugly. It can be sent to the nearest maintenance department for processing or dismantling the machine for cleaning by yourself.

If you have poor hands-on ability, you should still repair it for a professional).

3. Falling into non-clean water when the power is on, or falling into corrosive liquid or viscous liquid or other clean liquids regardless of whether the power is on or not.

1.Turn off the power as soon as possible.

2.If you fall into a corrosive liquid (e.g. seawater), rinse the machine with clean water immediately. Or immerse the machine in clean water and try to dilute the corrosive liquid inside.

3.Disassemble the machine as soon as possible. But take your time when disassembling the machine.

4.Rinse with alcohol or professional washing water.

5.Assembling. Or take the whole pile of what you took apart and hand it over to the repair point. Let the repair point clean and assemble it again for you.

It should be given as much as it can be blown dry with a little blowing.

That depends on what mobile phone I have experienced twice Disassemble the phone and dry the circuit board Don't be too anxious to use it at least after 2 days of complete drying It shouldn't be too much of a problem to change a new battery, my mobile phone is Samsung and Tianyu Follow the above methods to operate You can continue to use it.

Can't turn it on, you have to take it to the place where the phone is repaired, they have professional liquid cleaning, and it doesn't cost much, 30 yuan.

Look at the value of the phone! If it's so good, it's best to go to the repair shop and call the master to deal with it, so it's more thorough, like they do, it will only burn the machine, even if it's good, it's not thorough, and the motherboard has not been cleaned!

If it's 3-2 hundred, don't smell that gas, and go directly to the garbage truck. If it's 3-2 thousand, don't install the battery and go to the repair station to clean it.

Wait until it's dried with a blow dryer and then try to turn it on, no, if there is water, it will burn the ......

Take off the phone battery, wipe the phone dry, blow it with a hair dryer for a while, and then let it sit for a while to see if it works...

The hair dryer blows up, can it still be used later?