Duplex building with channel steel to make the partition nailed to the board, can it be used as a ba

You can make a bathroom, but you have to solve the problem of getting water and getting into the water. That is, connect the tap water from below, and then build a sewer pipe to connect the waste water and the sewage of the flush toilet to the main sewer. Install the water heater again, and you can take a shower again.

It can be done, the channel steel is built on the large core board, and then the cement board cover can be waterproofed, OK, or the surface of the steel plate can be waterproofed, of course, you can paste the bricks;It is also necessary to consider what type of channel steel is, and there should be no problem with the sewer pipe of the floor drain, mainly how to drain the sewer of the toilet, and if the sewer is a straight pipe, you don't need to consider this problem.

Yes, the walls are made of glass or other waterproof materials, and the floor is also waterproofed.

In the bathroom, there should be no problem in doing a good job of waterproofing and then making a bathroom, and the channel steel should be treated with anti-corrosion, and the wooden board should be treated with moistureso as not to rust.

Of course, you can make a bathroom, but the most important thing is whether you do a good job of waterproofing and going into the water, these two are the key.

Of course, you can, you can also lay bricks, but it depends on how waterproof you are. Waterproofing should be done by a professional waterproof team. If you want to lay bricks, please use small pieces.

It can be done, and bricks can also be laid. The main thing is to see if your pipe can go. Mainly drainage.

Square peg.

Planks are perishable.

OK. As long as the drainage effect is good, it is not mentioned.

The structure is no problem, but there are some fewer steps to do the bathroom, which may leave a lot of hidden dangers (water leakage?).）

Suggestion: 1- Do a layer of cast-in-situ (seven or eight centimeters thick) on the ground of this structure, then make a layer of mortar protective cushion (leveling), then do waterproofing (it is best to do 2 times, prevention), and finally carry out later construction (tiling, etc.).

2.The wall plank is very troublesome, first of all, the waterproof and load-bearing problem (wall tiling), it is best to brush a layer of thermal insulation and waterproof soft waterproof glue on the board, and then construction.

Anyway, it's best not to do this bathroom (you can do it for a short time), after a long time the wall tiles its own falling force is very large, the wooden board will always be damp, and the hidden danger will be great in the future (unless you do a few more waterproof layers and reinforcement layers, but the cost is too great - you can consider building the wall with red bricks).

Yes, but you have to be waterproof.

It's up to you how you use it

Select the cells that allow data to be entered, set the cell format - protect - unlock; Select the cells with formulas that are not allowed to be modified, and set the cell format - protect - check "Lock"; Tools - Protect - Protect the worksheet, you can set a password.