-
Anonymous users2024-01-23This is either due to the toilet itself (defect in production); Either it is the installation reason, that is, the bottom is not tightly sealed and leaks, so there is no suction.
-
Anonymous users2024-01-22Because the water pressure is not enough, the water tank should be put a little higher.
1. First of all, if the water level of the toilet inlet valve is caused by the water level of the toilet inlet valve, you can remove the inlet valve, remove the buckle, rotate it in the opposite direction, adjust it to the appropriate height, and then install the slag filter and water inlet pipe. 2. Secondly, if the toilet flush is weak, it may be that the toilet is blocked, it is recommended to dredge it with a dredger, or find a long water pipe, connect the faucet at one end, plug it into the toilet drain at one end, and then block the toilet mouth with a rag source, and finally open the faucet, and use the water pressure to dredge the pipe.
Flushing weakness is generally a small amount of water storage, adjust the height of the float of the water supply valve, and appropriately increase the water storage in the water tank
The amount of water can be increased in many ways, such as putting bottles in the tank. >>>More
The toilet is a very important piece of household equipment in daily life, so if it has problems, it may bring a lot of trouble to our lives. If your toilet flushes poorly, don't panic, here are some things you can do to fix the problem. >>>More
Common reasons for the weakness of flushing in toilets: 1. The side handle chain of the side press and side wrench toilet is long, which causes the water stop pad to stop the water quickly although it moves. Workaround: >>>More