How to buckle the buckle plate in the trapezoidal shed of the bathroom

Updated on Bathroom 2024-04-28
4 answers
  1. Anonymous users2024-01-23

    First, attach the rectangular part to the gusset, and then attach the two triangular parts. The master who makes the gusset should know everything.

  2. Anonymous users2024-01-22

    Diagonal paving is along the longest side.

  3. Anonymous users2024-01-21

    The four sides of the board are aligned with the groove on the ceiling and pressed on the inside and out.

  4. Anonymous users2024-01-20

    First, lay it out in a square material, and then the edge material can be cut.

Related questions
How to disassemble the roof light in the bathroom?
6 answers2024-04-28

First disassemble the gusset around the ceiling lamp, and then look at the hanging method above the ceiling lamp to determine the method of disassembly. >>>More

There are a lot of bubbles on the top floor of the shed, and there is water on the bathroom roof, I
3 answers2024-04-28

I can responsibly tell you that your house is seeping!

But there are a few issues that you need to be aware of: >>>More

How to deal with the water vapor points on the shed of the bathroom
1 answers2024-04-28

If there is no window, use a window to scrape the water off.

How to repair the leakage at the joints of the sewer pipes under the roof of the bathroom
1 answers2024-04-28

Experiment with cologne-fine seam glue. There must be no water during the drying process, otherwise it will not dry. After drying, it is completely transparent, and the thickness of 2 mm is fine.

The roof of the bathroom shed is leaking, and I don't want to cut the bricks, what do I need to do
1 answers2024-04-28

Clean the floor drain and around the sewer pipe, and re-seal it with the plugging spirit. Clean the shady corners around the wall and the ground, dry them with a hair dryer, and seal them with structural adhesive.