-
Anonymous users2024-01-23Re-slotted the power supply line on the wall in the bathroom to install a waterproof power socket in a suitable position, or use a reliable power cord to extend the power supply line of the electric heater, and draw electricity from the power socket in other places.
From the point of view of safety and permanent problem solving, it is recommended to consider slotted wiring in the bathroom wall and waterproof electrical outlets. This is a hassle, but safe, one-time solution to the problem.
-
Anonymous users2024-01-22Connect the power cord to the water heater or install an outlet in the bathroom.
-
Anonymous users2024-01-21Install an outlet in the bathroom.
Gas water heaters are not easy to use, and the water flow rate should be considered first. >>>More
According to what you say.
The size of the bathroom is OK, 900 * 900 space can be used, the installation of the electric water heater is convenient, that is, there are two hanging grooves on the back of the water heater, and two pendants are fixed with expansion bolts on the wall, and it can be hung up, which is very reliable. It is also easy to disassemble when moving, as long as the water is removed, one person can move it. >>>More
This is there but the detection is missing, it is caused by the line being disconnected or falling off, this can measure the resistance of the ground wire. Some are fake, only a small section of the grounding wire is inserted, and some are which part of the grounding wire has fallen off.
If used.
It is necessary to do the bathroom waterproof, not waterproof when you take a bath. >>>More
There is no need to unplug the plug of the bathroom water heater frequently, there is a temperature control box inside the storage type electric water heater, after heating the water, do not pull the plug and keep it in the turned on state, it will always remain at a constant temperature. At this point, it doesn't consume a lot of electrical energy. Once the power is turned off, the hot water inside will gradually cool down and will be reheated when the power is turned on again, which will consume more electricity. >>>More