-
Anonymous users2024-01-23There are elbows, tees, oil blades, pipe hoops, etc.
-
Anonymous users2024-01-22Elbow tee straight through takeover, not too big, there are three points five minutes one inch one and a half inches two inches.
The PVC pipe joint is also a place that is easy to seep water, and the re-melt pipe will be short, and it needs to be replaced again if it cannot be satisfied.
Start by identifying where the water is leaking. If it is only a joint leakage, under the premise that the quality of the pipe is qualified, the joint can be replaced or a leak-proof sealing tape and AB sealant can be added to the joint; If the quality of the pipe is not good, the pipe should be replaced. You can also apply the adjusted AB glue in the leaking place, and then wrap a layer of ribbon on it, so that the ribbon is soaked with AB glue and then apply a layer of AB glue on the ribbon, and the whole process can be divided into two or many times.
Your water pipe is PPR pipe, the joint must be hot melt, there is no glue to replace, you can go to the place where the pipe is sold to borrow it.
It won't last long, you have to do it solidly, otherwise it won't take long.
Disassemble or replace the leaking pipe, and connect it directly after applying it with PVC special glue, and using raw material tape and black tape can not prevent water leakage. If the leakage is not very serious, it is okay to apply glass glue on the outside of the pipe or in the leaky area, but the premise is that when applying glass glue, the tube must be dry and kept for at least 12 hours.