The water pipe joint from the bathroom, the leakage was originally hot melting, and there was no hot

Start by identifying where the water is leaking. If it is only a joint leakage, under the premise that the quality of the pipe is qualified, the joint can be replaced or a leak-proof sealing tape and AB sealant can be added to the joint; If the quality of the pipe is not good, the pipe should be replaced. You can also apply the adjusted AB glue in the leaking place, and then wrap a layer of ribbon on it, so that the ribbon is soaked with AB glue and then apply a layer of AB glue on the ribbon, and the whole process can be divided into two or many times.

Disassemble or replace the leaking pipe, and connect it directly after applying it with PVC special glue, and using raw material tape and black tape can not prevent water leakage. If the leakage is not very serious, it is okay to apply glass glue on the outside of the pipe or in the leaky area, but the premise is that when applying glass glue, the tube must be dry and kept for at least 12 hours.

It won't last long, you have to do it solidly, otherwise it won't take long.

It is definitely not possible to wipe with glue, like this I generally can reconnect if I can reconnect, and if I can't reconnect it, I will drop the section of pipe in front of the leakage, and carefully shave out the pipe in the pipe fittings with a razor, and reconnect it with a live joint. It should be noted that you must be careful when shaving off the 110 old pipe in the pipe fitting, otherwise it will be more troublesome if the pipe fitting is damaged.

As long as you have a hot melt machine, you can change it yourself, which is actually very simple.