-
Anonymous users2024-01-23Gypsum board ceiling downlight holes can be sawed.
Let's draw a proper circle first, you don't need to be taught how to draw this, right? Then find a 12-inch hacksaw blade, break it from the middle, insert the saw blade into the drywall, and see it along the circle.
1.The digging hole should be dug according to the diameter of the downlight, too large or too small will affect the use and appearance;
2.The location of the digging light hole should be located according to the position of the design drawing, that is, the position of the lamp head box where the wires are arranged.
3.When digging the lamp hole and preparing for wiring, it should be forbidden to turn off the main switch of the downlight line in the house to prevent the danger of electric shock.
You first need to know the size of the opening of the downlight, and then you can use two ordinary nails to nail it to the wooden strip, and the distance between the two nails is half the size of the opening; Then determine the center of the hole, drive a nail into the center, and then make a circle back and forth like a compass so that the plasterboard can be broken - at this point, a hole in the downlight is opened. >>>More
There is no wire in the gypsum board ceiling downlight hole, you can connect one hole after another from the downlight hole, pull the wire through, and then connect the electricity.
Adopt the parallel method; If it is a line to the end, peel off the sheath skin at the corresponding wiring position, peel off the insulation skin of the zero fire wire about 1 cm apart, and introduce the downlight terminal with a soft wire winding method. >>>More
At first glance, it is not in the construction order, and the opening of the downlight hole must be completed before scraping putty. >>>More
This depends on the size of your downlight to know the size of the opening. The common sizes of the openings of downlights are: >>>More