-
Anonymous users2024-01-23There is no wire in the gypsum board ceiling downlight hole, you can connect one hole after another from the downlight hole, pull the wire through, and then connect the electricity.
-
Anonymous users2024-01-22Find the power interface, you can use the wire pipe to put the wire in the ceiling.
You first need to know the size of the opening of the downlight, and then you can use two ordinary nails to nail it to the wooden strip, and the distance between the two nails is half the size of the opening; Then determine the center of the hole, drive a nail into the center, and then make a circle back and forth like a compass so that the plasterboard can be broken - at this point, a hole in the downlight is opened. >>>More
Adopt the parallel method; If it is a line to the end, peel off the sheath skin at the corresponding wiring position, peel off the insulation skin of the zero fire wire about 1 cm apart, and introduce the downlight terminal with a soft wire winding method. >>>More
At first glance, it is not in the construction order, and the opening of the downlight hole must be completed before scraping putty. >>>More
It will be useful to save this acceptance diagram later.
Ceiling gypsum board does not have formaldehyde. The raw materials used in gypsum board do not contain formaldehyde. >>>More